AVSPARE.COM
parts catalog

PLATE 2559645 - Caterpillar



2559645 PLATE Caterpillar parts 325C PLATE
Rating:
20
Alternative (cross code) number:
CA2559645
255-9645
2559645
Caterpillar 2559645 PLATE

Buy PLATE 2559645 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 2559645:

EXCAVATOR  325C   Caterpillar
Number on catalog scheme: 6
 
  For full view, you need register

Information:


Illustration 1 g03842628
Schematic of the parking brake solenoids
This diagnostic code is associated with the parking brake solenoid 1. This diagnostic code is recorded when the Power Train/Chassis Electronic Control Module (ECM) has determined that the current to the controller is above normal.The possible causes of this diagnostic code are listed:
The energize circuit of the controller is shorted to frame ground
The controller has failed
The ECM has failed. This is unlikelyNote: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0681 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the ECM will be unable to control the parking brake solenoid. The parking brake will always be engaged.Test Step 1. CHECK THE CONTROLLER
Turn the battery disconnect switch and the key start switch to the ON position.
Disconnect the harness from the controller.
At the harness connector for the controller, place a jumper wire from connector contact 2 (wire G730-PK(Pink)) to connector contact 4 (wire H808-WH(White)).
Observe the status of the diagnostic code. Expected Result:The diagnostic code is active. Then, the diagnostic code is not active when the jumper wire is removed.Results:
YES - The circuit is correct. The controller has failed.Repair: Repeat this test "CHECK THE CONTROLLER" in order to verify the controller failure. Replace the controller.STOP
NO - CID 0681 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE CONTROLLER FOR A SHORT TO GROUND
Turn the key start switch and the battery disconnect switch to the OFF position.
The harness remains disconnected from the controller.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J2-3 (wire G730-PK(Pink)) to all contacts that are used in the machine harness connectors for the ECM.
Observe the resistance. Expected Result:Each resistance measurement is greater than 5 ohms.Results:
YES - Each resistance measurement is greater than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NO - One or more resistance measurements are less than 5 ohms. There is a short in the machine harness or the controller harness. The short is between J2-3 (wire G730-PK(Pink)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. Repair the controller harness or replace the controller harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE IS STILL ACTIVE
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the battery disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0681 FMI 06. Expected Result:The CID 0681 FMI 06 is active.Results:
YES - The CID 0681 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this

Caterpillar parts catalog:

Caterpillar parts catalog
325 CR SUPPLEMENT FOR TRACK-TYPE EXCAVATOR /COMPACT RADIUS HYDRA/ BKW00326-UP (MACHINE)
325C CR TRACK-TYPE EXCAVATOR /COMPACT RADIUS HYDRA/ BKW00343-UP (MACHINE)
325C L CR TRACK-TYPE EXCAVATOR /COMPACT RADIUS HYDRA/ BKW00328-UP (MACHINE)


Parts plate Caterpillar catalog:

7C8634 PLATE
1090, 1190, 1190T, 120H, 120H ES, 120H NA, 120K, 120K 2, 1290T, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 143H, 160H, 160H ES, 160H NA, 160K, 163H NA, 214B, 224B, ...
7C6672 PLATE-CLAMP
120H, 120H ES, 120H NA, 12H, 135H, 135H NA, 214B, 30/30, 3114, 3116, 3126, 3126B, 3126E, 3176, 3176B, 320 L, 320B, 322 FM L, 322 LN, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, ...
5P9891 PLATE-WARNING
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 307, 307B, 307D, 307E, 308E, 311, 311B, 311C, 312, 312B, 312B L, 312C L, 313B, 314C, 315, 315B, 315B FM L, 315C, 317, 318B, 318C, 319C, 320 L, 320B, 3...
2531346 PLATE-WARNING
1290T, 1390, 2491, 2590, 307C, 307D, 307E, 308C, 308D, 308E, 308E CR, 308E SR, 308E2 CR, 311D LRR, 311F LRR, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR...
1673862 PLATE-RETAINER
325C, 328D LCR, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 993K
1884167 PLATE
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 324E, 324E L, 324E LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 325D M...
2042677 PLATE-VALVE
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 322C, 322C FM, 324D, 324D FM, 324D FM LL, 324D L, 324D LN, 324E, 324E L, 324E LN, 325C, 325C FM, 325D, 325D FM, 325D FM LL, 325D L, 325D M...
1132824 PLATE AS
1090, 1190, 1190T, 1390, 2290, 2390, 2391, 320 L, 320B, 320B FM LL, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D FM, 324D FM LL, 325, 325 L, 325B, 32...
0940579 PLATE
320B, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325, 325 L, 325 LN, 325B, 325B L, 325C, 325C FM, 325D, 32...
0940578 PLATE
320B, 320C, 320C FM, 320D, 320D FM, 320D FM RR, 322B L, 322C, 322C FM, 323D LN, 323D SA, 323E L, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325, 325 L, 325 LN, 325B, 325B L, 325C, 325C FM, 325D, 32...
1348951 PLATE
115, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325B L, 325C, 325D, 325D L, 326D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330, 330 L, 330B, 330B L, 330C, 330C L, 330D, 330D L, 330...
1673865 PLATE-SEPARATOR
325C, 328D LCR, 330C, 330C FM, 330C L, 330C MH, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.