AVSPARE.COM
parts catalog

TUBE AS 2559777 - Caterpillar



2559777 TUBE AS Caterpillar parts TUBE
Rating:
31
Alternative (cross code) number:
CA2559777
255-9777
2559777
Caterpillar 2559777 TUBE AS

Buy TUBE AS 2559777 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Hydraulic Implement System
Look at the Fluid Level
Hot fluid can cause burns.At operating temperature, the hydraulic tank is hot and under pressure.Remove the fill cap only when the engine is stopped, and the cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure.
The warning label by the hydraulic tank fill cap reads as follows:
DO NOT REMOVE FILLER CAP IF FLUID TEMPERATURE IS ABOVE 190°F (88°C). STEAM MAY BE PRESENT.
This reservoir contains a water-glycol fire resistant fluid. DO NOT ADD OTHER HYDRAULIC FLUIDS.See maintenance guide for correct drain and fill procedure.
Never start the machine, if the fluid is not visible in the sight gauge, to avoid any pump damage.Water-glycol fluid must not be mixed with petroleum base oil. If the system becomes contaiminated with petroleum based products, shut down the machine immediately. Oil contamination mixed with water-glycol will cause a sludge that plugs filters. Also, it will decrease the effectiveness of the fluid for fire resistance.Contact your Caterpillar dealer for proper procedure to flush and clean the system if contaminated.Since the commercially available water-glycol fluids do vary some in their properties, avoid mixing fluids whenever possible. Your fluid supplier can furnish information regarding the necessary tests for proper maintenance of the fluid being used.
1. Maintain the fluid to the ADD mark in the sight gauge.Fire resistant hydraulic fluid (water-glycol) should be checked and fluid added (as necessary) at the beginning of the shift when fluid is cool, if possible. 2. If necessary to add fluid, tilt the cover back. Remove the fluid fill cap. Add fluid through the fill tube.Fuel Tank
Fuel Filling and Dirt Removing
Remove any dirt from the boot area around the fuel cap. Dirt soaked with fuel could be a potential fire hazard. 1. Lift the fuel cap retainer from cap and tilt the cap back. 2. Remove the dipstick and maintain the fuel to the 80% mark on the dipstick. 3. Close the fuel cap and latch.Engine Air Precleaner
Remove Dirt Accumulation
1. Loosen the wing nut and remove the cover.2. Remove the bowl and empty it. Clean out the bowl.3. Replace the bowl. Replace the cover and tighten the wingnut.


Parts tube Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.