AVSPARE.COM
parts catalog

CONT GP- 2559810 - Caterpillar



2559810 CONT GP- Caterpillar parts CONT
Rating:
21
Alternative (cross code) number:
CA2559810
255-9810
2559810
Caterpillar 2559810 CONT GP-

Buy CONT GP- 2559810 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Pressure Air - 205 kPa (30 psi) Maximum
1. Direct the air inside the element along the length of the pleats. 2. Direct the air outside the element along the length of the pleats. Direct the air inside the element along the length of the pleats. Inspect the element.Water - 280 kPa (40 psi) Maximum
1. Direct the water inside the element along the length of the pleats. 2. Direct the water outside the element along the length of the pleats. Rinse and air dry thoroughly. Inspect the element.Detergent
1. Wash the element in warm water and a nonsudsing household detergent. 2. Rinse with clean water. See the preceding topic.3. Air dry thoroughly. Inspect the element.Inspecting Element
Insert a light inside each clean and dry element and inspect. Discard the element if rips or tears are found.Storage
Dry thoroughly, then wrap and store all good elements in a clean, dry place.Engine Air Precleaner - Inspect and Clean
1. Inspect visually. The cup should be emptied whenever dirt reaches the indicator mark. 2. Loosen the wing nut on top of the cap and remove the cap. 3. Remove and empty the cup. Wipe the cup clean. 4. Install the cup and the cap. Tighten the wing nut finger tight only. Do not use a tool.5. Periodically remove the precleaner cup and the cap and wash them in water.Seat Belt
Inspect
Inspect the condition of the seat belt and all mounting hardware frequently. Replace the seat belt or any part of the mounting hardware, if it is damaged.
Replace the seat belt every 3 years regardless of its condition or appearance.
Windshield Wipers and Washer (If Equipped)
Inspect Blades - Refill Bottle
1. Inspect the windshield wiper blades. Replace them if they are worn or damaged, or if streaking occurs.
When operating in freezing temperatures, use a nonfreezing window washer solvent. Any commercially available nonfreezing window washer solvent can be used.
2. Fill the windshield washer bottle, through the filler neck located on the left outside of the base of the operator's compartment.Fuses
Inspect - Change Fuses
1. The fuse panel is located inside the cab on the right side of the operator's seat in the operating console. 2. Inspect the fuses. Replace any fuse if the element is broken.
If it is necessary to replace fuses frequently, consult your Caterpillar dealer.
Ether Starting Aid
Install or Remove Ether Cylinder
(typical installation shown)
Ether is poisonous and flammable.Breathing ether vapors or repeated contact of ether with skin can cause personal injury.Use ether only in well ventilated areas.Use ether with care to avoid fires.Do not smoke while changing ether cylinders.Do not store ether cylinders in the operator's compartment or living areas.Do not store ether cylinders in direct sunlight or at temperatures above 49°C (102°F).Discard ether cylinders properly. Do not puncture or burn ether cylinders.Keep ether cylinders out of the reach of unauthorized personnel.
The ether cylinder valve is located in the engine compartment on the right side of the machine.Initial Installation
1. Remove the protective plug (1) from the ether cylinder valve. Store the plug in the threaded holder (2). 2. Install the gasket


Parts cont Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.