AVSPARE.COM
parts catalog

ACCUMULATOR 2559973 - Caterpillar



2559973 ACCUMULATOR Caterpillar parts ACCUMULATOR
Rating:
26
Alternative (cross code) number:
CA2559973
255-9973
2559973
Caterpillar 2559973 ACCUMULATOR
Weight: 2 pounds 1 kg.

Buy ACCUMULATOR 2559973 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Transmission
Measure the Oil Level
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
The transmission oil dipstick is located in the operator compartment under the floor access plate in front of the operator's seat.Maintain the oil between the marks on dipstick at LOW IDLE. Add oil through fill tube if necessary.Bevel Gear Compartment
Measure the Oil Level
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.
The bevel gear oil dipstick is located in the operator compartment under the floor access plate in front of the operator's seat.1. Measure the oil level.2. Maintain the oil between the marks on dipstick. Add oil through fill tube if necessary.Inspect completely around and under the machine for leaks.Bucket Linkage
Lubricate the Fittings
Lubricate 14 fittings (7 each side).Bucket Pivot Points
Lubricate the Fittings
Lubricate 4 fittings (2 each side)Cab Air Filters
Clean the Filter Elements
Clean the filter elements daily when there is a reduction of air circulation. 1. Remove the covers.2. Remove and clean the filter elements. See "Cleaning the Filter Elements."3. Install the cleaned filter elements.4. Replace the covers and tighten.Cleaning the Filter Elements
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Elements can be cleaned with pressure air or pressure water.1. Wash them in clean water and household detergent.2. Rinse thoroughly with clear water, and blow dry with pressure air.
Do not clean the elements by bumping or tapping them.Inspect the elements after cleaning. Do not use an element with damaged pleats, gaskets or seals.When cleaning with pressure water, use 280 kPa (40 psi) maximum pressure to prevent element damage.
3. Direct air or water along pleats inside and outside of the element.4. Air dry and inspect the element to see if any debris remains visible.


Parts accumulator Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.