AVSPARE.COM
parts catalog

NUT 2559992 - Caterpillar



2559992 NUT Caterpillar parts 901C, 902C, 903C NUT
Rating:
19
Alternative (cross code) number:
CA2559992
255-9992
2559992
Caterpillar 2559992 NUT

Buy NUT 2559992 Caterpillar genuine, new aftermarket tractor parts with delivery
COMPACT WHEEL LOADER,

Compatible models Caterpillar: 2559992:

COMPACT WHEEL LOADER  901C   902C   903C   Caterpillar
Number on catalog scheme: 5
 
  For full view, you need register

Information:


Illustration 1 g00825756
Schematic of the Transmission Oil Temperature SensorThe CID 0041 FMI 03 diagnostic code is recorded when the power train electronic control module (ECM) reads the voltage of the sensor supply circuit (wire 709-OR) as more than 8 DCV. This failure may cause the transmission oil temperature to be incorrect. This will affect the quality of the shift.The possible causes for this diagnostic code are listed:
The signal circuit for the sensor is open.
The sensor supply circuit to the transmission oil temperature sensor is shorted to the +battery circuit.
A sensor has failed.
The power circuit or the ground circuit has failed.
The power train ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0041 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK FOR POWER AT THE SENSOR
Do not disconnect the harness connector from the sensor.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply wire (contact "A").
Measure the voltage from contact "A" to frame ground.Expected Result:The voltage is approximately 8 volts.Results:
OK - The voltage is approximately 8 volts. Proceed to Test Step 3.
NOT OK - The voltage is not approximately 8 volts. The supply circuit in the machine harness has failed. Proceed to Test Step 2.Test Step 2. CHECK THE WIRING HARNESS OF THE SENSOR FOR AN OPEN CIRCUIT
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from the sensor.
At the harness connector for the sensor, connect a jumper wire between contact "B" and contact "A".
Disconnect the machine harness connector(s) from the ECM.
At the harness connector for the ECM, measure the resistance between contact J1-16 (wire 962-OR) and contact J2-12 (wire 709-OR).Expected Result:The resistance measurement is less

Caterpillar parts catalog:

Caterpillar parts catalog
901C Compact Wheel Loader W4T00001-UP (MACHINE) POWERED BY C1.8 Engine
902C Compact Wheel Loader W5T00001-UP (MACHINE) POWERED BY C2.4 Engine
903C Compact Wheel Loader W6T00001-UP (MACHINE) POWERED BY C2.4 Engine


Parts nut Caterpillar catalog:

5C2874 NUT
120G, 120H, 120H ES, 120H NA, 120M, 12G, 12H, 12H ES, 12H NA, 12M, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140M, 143H, 14G, 14H NA, 14M, 160G, 160H, 160H ES, 160H NA, 160M, 163H, 163H NA, 1...
6V8187 NUT
1090, 1190, 1190T, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 1290T, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 135H, 135H NA, 1390, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 143H, 14H, ...
5C8312 NUT
10-20B, 1090, 1190, 1190T, 120H, 120H ES, 120H NA, 120K, 120K 2, 1290T, 12H, 12H ES, 12H NA, 12K, 135H, 135H NA, 1390, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 143H, 14H, 14H NA, 14M, 160H, 160H ES...
8T4001 NUT
115, 1190T, 1290T, 1390, 14G, 214B, 224B, 2290, 2384C, 2390, 2391, 2470C, 2484C, 2491, 2570C, 2590, 2670C, 2864C, 30/30, 307, 307B, 307C, 308C, 3126B, 320B FM LL, 320C, 320D L, 324D, 324D L, 324D LN, ...
8T3597 NUT-WELD
1090, 1190, 1190T, 1290T, 1390, 216, 216B, 216B3, 226B, 226B3, 228, 2290, 236, 236B, 236B3, 2384C, 2390, 2391, 242B, 246C, 247, 2470C, 247B, 247B3, 248, 2484C, 2491, 256C, 2570C, 2590, 262C, 262C2, 26...
6V9169 NUT
10 FT, 10-20B, 1090, 10B, 115, 1190, 1190T, 120M, 120M 2, 1290T, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14H, 14H NA, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16G, 16H, 16M, 216, 228,...
0964876 NUT
303.5E, 303E CR, 304E, 305.5E, 305E, 307, 307E, 308C, 308E, 308E SR, 308E2 CR, 311, 311B, 311C, 311D LRR, 311F LRR, 312, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E ...
6F7045 NUT-FULL
1090, 1190, 1190T, 120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 1290T, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 1390, 140B, 140G, 140H, 140H ES, 1...
8H5303 NUT
1090, 1190, 1190T, 120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 1290T, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 1390, 140B, 140G, 140H, 140H ES, 1...
2579607 NUT
901C, 902C, 903C
2559994 NUT
901C, 902C, 903C
2580041 NUT
901C, 902C, 903C
4195586 NUT-JAM
901C, 902C, 903C, SE60 V XW
4M5286 NUT
613, 621B, 623, 627, 627B, 631C, 633C, 641B, 657B, 769, 772, 988
2H6886 NUT
621, 631C, 651, 657, 824B, 826B, 834, 988, 992
9M4148 NUT
621, 631C, 651, 657, 824B, 826B, 834, 988, 992
4D7470 NUT
12E, 14E, 824B, 825B, 966C, 980, 992
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.