AVSPARE.COM
parts catalog

TUBE AS 5V3877 - Caterpillar



5V3877 TUBE AS Caterpillar parts 950B, 950B/950E TUBE
Rating:
19
Alternative (cross code) number:
CA5V3877
5V-3877
5V3877
Caterpillar 5V3877 TUBE AS
Weight: 13 pounds 6 kg.

Buy TUBE AS 5V3877 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Compatible equipment models: 5V3877:

WHEEL LOADER  950B   950B/950E   Caterpillar
Number on catalog scheme: 8
 
  For full view, you need register

Information:


Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (−) to battery negative (−).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
When starting from another machine, make sure that the machines do not touch. This can prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 24 volt starting system. Use only the same voltage for jump starting. Use of a higher voltage damages the electrical system.
Use of Jump Start Cables
When the auxiliary start receptacle is not available, use the following procedure.
Make the initial determination of the failure to crank. Refer to Special Instruction, REHS0354, "Use of 6V-2150 Starting Charging Analyzer Group". The procedure is applicable even if the machine does not have a diagnostic connector.
Move the transmission of the stalled machine into the STOP position. Engage the parking brake. Lower all attachments to the ground. Move all controls to the HOLD position.
Turn the engine start switch on the stalled machine to the OFF position. Turn off all accessories.
Turn on the battery disconnect switch on a stalled machine.
Move the machine that is being used as a power source so that the jump-start cables can reach the stalled machine. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the machine that is being used as a power source. If you are using an auxiliary power source, turn off the charging system.
Check the battery caps for correct placement and for correct tightness. Make these checks on both machines. Make sure that the batteries in the stalled machine are not frozen. Check the batteries for low electrolyte.
Illustration 1 g02894341
Open the hood. The batteries are located on the left side of the engine compartment.
Connect the positive jump-start cable to the positive battery terminal. Do not allow positive cable clamps to contact any metal except for the positive battery terminal.
Connect the positive jump-start cable to the positive terminal of the boost source. Use the procedure from Step 9 in order to determine the correct terminal.
Connect one end of the negative jump-start cable to the negative terminal of

Caterpillar parts catalog:

Caterpillar parts catalog
950B WHEEL LOADER 22Z00001-03188 (MACHINE) POWERED BY 3304 ENGINE
950E WHEEL LOADER 22Z03189-UP (MACHINE) POWERED BY 3304 ENGINE
950B WHEEL LOADER 63R00001-06053 (MACHINE) POWERED BY 3304 ENGINE
950E WHEEL LOADER 63R06054-UP (MACHINE) POWERED BY 3304 ENGINE
950B WHEEL LOADER 65R00001-02823 (MACHINE) POWERED BY 3304 ENGINE
950B WHEEL LOADER 65R02824-03088 (MACHINE)
950E WHEEL LOADER 65R03089-UP (MACHINE) POWERED BY 3304 ENGINE


Parts tube Caterpillar catalog:

2P2697 TUBE AS-AIR VENT
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 215, 235B, 3304, 3304B, 3306, 3306B, 515, 518C, 525, 545, 572G, 572R, 615C...
8N7318 TUBE AS
120B, 120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 235, 235B, 330, 330 L, 3304, 3304B, 3306, 3306B, 3306C,...
8N7315 TUBE AS-OUTLET
120B, 120G, 12G, 12H, 12H ES, 12H NA, 130G, 140B, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160G, 160H, 160H ES, 160H NA, 163H NA, 1673C, 235, 235B, 330, 330 L, 3304, 3304B, 3306, 3306B, 3306C,...
4S8602 TUBE ASSEM.
613C II, 615C, 69D, 7271, 769C, 773B, 776, 777, 777B, 834B, 834G, 834H, 836G, 836H, 936, 936F, 950, 950B, 950B/950E, 950F, 950F II, 950G, 950G II, 960F, 966C, 966G, 966H, 966R, AD55, CX31-C9I, D400, D...
1W1631 TUBE ASSEM.
515, 517, 950B, 963, G936
8N1965 TUBE-DISPOSAL
815B, 930, 950B, 966D, 966F, 966F II, 970F, 972G, D7H
2V7990 TUBE AS
814B, 815B, 826C, 916, 926, 936, 936F, 950B, 950F, 950F II, 966D, 966F, 980C, 980F, CS-643, G936, IT18, IT18B, IT28, IT28B
7W9553 TUBE AS-OUTLET
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 160G, 160H, 160H ES, 160H NA, 163H NA, 518C, 528B, 530B, 936, 936F, 950B, 950B/950E
7G8141 TUBE AS
936, 936F, 950B, 950B/950E, 950F, 950F II, 966C, G936
7E6796 TUBE AS
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 160G, 160H, 160H ES, 160H NA, 163H NA, 518C, 528B, 530B, 936, 936F, 950B/950E
9C6281 TUBE AS
950B, 950B/950E
7V6613 TUBE
814B, 815B, 966D
6W8949 TUBE AS
950B, 950B/950E
6W8948 TUBE AS
950B, 950B/950E
9V7324 TUBE AS
950B, 950B/950E
4W1007 TUBE
950B, 950B/950E
4W1008 TUBE AS
950B, 950B/950E
5V3878 TUBE AS
950B, 950B/950E
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.