AVSPARE.COM
parts catalog

PLATE A 9V8994 - Caterpillar



9V8994 PLATE A Caterpillar parts PLATE
Rating:
21
Alternative (cross code) number:
CA9V8994
9V-8994
9V8994
Caterpillar 9V8994 PLATE A
Weight: 0.78 pounds 0 kg.

Buy PLATE A 9V8994 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Typical Example1. Disconnect lubrication lines (1) from each end of the tie rod.2. Loosen nuts (3) until they are even with the end of the ballstud.3. Put a jack under the nuts and ballstuds, and apply force to them. Hit the socket area where the ballstuds are seated with a hammer to break them loose from their tapers.4. Remove locknuts (3).5. Use Tooling (A) to remove the ball stud. Refer to M0080743, Tool Operating Manual, Ball Stud Breaker for the correct procedure to remove the ball stud. Repeat this step for the remaining tie rod ball studs.6. Use Tooling (B) to support the weight of tie rod (2). The weight of tie rod (2) is approximately 103 kg (227 lb.). Remove tie rod (2). The following steps are for installation of the tie rods.7. Put 2P2506 Thread Lubricant on the threads and taper of the ballstud.8. Fasten tie rod (2) to a floor jack. Put the tie rod in position, and install two nuts (3). Tighten the nuts to a torque of 2550 100 N m (1880 75 lb.ft.).9. Connect lubrication lines (1) to each end of the tie rod.10. Check the front wheel alignment. See 789 Truck Steering System in Testing And Adjusting.


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.