AXLE GP-DRIVE 3236072 - Caterpillar

3236072 AXLE GP-DRIVE Caterpillar parts 730C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3236072
323-6072
3236072

Buy AXLE GP-DRIVE 3236072 Caterpillar genuine, new aftermarket tractor parts with delivery
ARTICULATED TRUCK, EJECTOR TRUCK,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Polaris Low Gear, 47 Tooth, Genuine OEM Part 3236072, Qty 1

$172.99

18 Mar 2021

-: -

Polaris Low Gear, 47 Tooth, Genuine OEM Part 3236072, Qty 1
For schematic location 23 only || See product description below for vehicle fitment or to verify fitment for your specific vehicle, please contact us, and provide us with your VIN that can be found on your vehicle or your insurance card.

Number on catalog scheme:

Caterpillar 3236072 Parts scheme AXLE GP-DRIVE

For full view, you need register

Compatible equipment models: 3236072:

ARTICULATED TRUCK 730C

EJECTOR TRUCK Caterpillar

Information:

Assembly Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.
Note: Check the condition of the O-rings. If the O-rings are worn or damaged, use new parts for replacement.
Illustration 1 g00601407
Install injection actuation pressure control valve (9) in block assembly (2), if the injection actuation pressure control valve was removed during the disassembly procedure. Tighten the injection actuation pressure control valve to a torque of 50 5 N m (37 4 lb ft).
Install spacer (10) and nut (11), if the spacer and the nut were removed during the disassembly procedure. Tighten the nut to a torque of 5.5 1.5 N m (49 13 lb in).
Illustration 2 g00601329
Install plugs (7) and plug (8), if the plugs were removed during the disassembly procedure. Tighten plugs (7) and (8) to a torque of 15.5 0.5 N m (11 0.4 lb ft).
Illustration 3 g00601405
Install four O-rings (5) between the block assembly and compensator (1). Lightly lubricate the O-rings with clean engine oil.
Install plug (6) in the compensator, if the plug was removed during the disassembly procedure. Tighten the plug to a torque of 25 3 N m (18 2 lb ft).
Illustration 4 g00601324
Install four O-rings (4) in block assembly (2). Lightly lubricate the O-rings with clean engine oil.
Install plugs (3) in compensator (1), if the plugs were removed during the disassembly procedure. Tighten the plugs to a torque of 10.0 0.2 N m (89 2 lb in). End By:
Install the injection actuation pressure control valve. Refer to Disassembly and Assembly, "Injection Actuation Pressure Control Valve - Install".