BEARING-SLEEVE 5088422 - Caterpillar

Neutralizer Function ( 420E and 430E)
The operator may momentarily neutralize the transmission by pressing the "neutralizer" switch. While the switch is held, the transmission is neutralized. The transmission returns to the previous gear when the "neutralizer" switch is released. The transmission returns to a lower gear if the switch is released within 1.2 seconds. Disengaging the "directional" clutch neutralizes the transmission, and the speed clutch remains engaged. This improves shift speed when the transmission is put back into gear. Normal autoshift operation may resume before the five seconds have expired if a speed change or a direction change occurs. If the switch is held continuously for longer than 3 minutes, a level 2 diagnostic code (CID 0629 - FMI 04) will be logged. After the diagnostic code has been cleared the transmission shall remain neutralized until the shift lever is cycled to neutral and back to a valid gear.Neutralizer Function ( 414E and 416E)
The operator may momentarily neutralize the transmission by pressing the neutralizer switch. While the switch is held, the transmission is neutralized. The transmission returns to the previous gear when the neutralizer switch is released. Disengaging the direction clutch neutralizes the transmission, and the speed clutch remains engaged. This improves shift speed when the transmission is put back into gear. The neutralizer switch is used to neutralize the transmission. The transmission is neutralized while the switch is held. If the switch is held continuously for longer than 3 minutes, a level 2 diagnostic code (CID 0629 - FMI 04) will be logged.Ride Control Switch
Illustration 11 g01230329
A three-position switch enables Ride control. In the held middle OFF position, the ride control function is disabled. The Ride Control function is held in the on position when the switch is in the ON position. In the held AUTO position, the ride control function activates the ride control solenoid valve when the ground speed is greater than a set limit. The ride control solenoid valve is deactivated when the ground speed is at least 1 km/h less than the set limit. The default set limit for AUTO is 9 km/h. "Caterpillar Electronic Technician (ET)" will be used to change the set limit. (In summary, in the ON position ride control is enabled, in the OFF position ride control is disabled, in the AUTO position ride control depends on the ground speed.) For the purpose of calculating ground speed a nominal tire radius of 635 mm (25 inch) shall be used.A pressure switch is placed in