BOLT 4152783 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 2010739 CABLE AS
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 23% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Inspect the static switch thermistor packing slip number (PS #) and replace if number is 22266, 22879, 23360. Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-20000 hrs,
0-12 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 4.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Shut down MMU in accordance with the shutdown procedure in Systems Operation/Testing and Adjusting, RENR9988.
2. Remove the Static Switch Assembly from flywheel cabinet (MMU) in accordance with the removal procedure in Systems Operation/Testing and Adjusting RENR9988.
Note: The Active Power Modules (APM) will need to be removed to gain full access to the Static Switch Assembly.
Image1.1.1
Image1.1.2
3. Inspect the thermistor packing slip number. If the packing slip number (PS #) is 22266, 22879 or 23360, replace thermistor.
Caution: Do not pull on the thermistor lead or apply excessive torque to remove.
4. To remove the thermistor, unscrew with 1/4 inch wrench or needle-nose pliers. If zip tied to a standoff, remove the zip tie as well.
5. Install new thermistor hand tight. Do not torque. Be sure to plug the thermistor connector into the SSI.
Image1.2.1
Image1.2.2
6. Reinstall the Static Switch Assembly in accordance in Systems Operation/Testing and Adjusting RENR99887.
Restore power to flywheel cabinet. No calibration necessary.