CLAMP-V BAND 4W9160 - Caterpillar

Product Description
Features
The two UPS Network Management Cards (NMC) mentioned below are web-based, IPv6 Ready products that manage supported devices using multiple open standards such as:
Hypertext Transfer Protocol (HTTP).
Simple Network Management Protocol versions 1 and 3 (SNMPv1, SNMPv3).
File Transfer Protocol (FTP).
Telnet
Secure SHell (SSH).
Hypertext Transfer Protocol over Secure Sockets Layer (HTTPS).
Secure CoPy (SCP).The Network Management Card:
Provides UPS control and self-test scheduling features.
Provides data and event logs.
Supports using a Dynamic Host Configuration Protocol (DHCP) or BOOTstrap Protocol (BOOTP) server to provide the network (TCP/IP) values of the NMC.
Enables you to configure notification through event logging (by the NMC and Syslog), e-mail, and SNMP traps. You can configure notification for single events or groups of events, based on the severity level or category of events.
Provides export ability to a user configuration (.ini) file from a configured card to one or more unconfigured cards without converting the file to a binary file.
Provides a selection of security protocols for authentication and encryptionThe Network Management Card 2 includes all Network Management Card features and the following:
Provides two USB ports.
Supports two universal input/output ports, to which you can connect:
Temperature or temperature/humidity sensors.
Relay input/output connectors that support two input contacts and one output relay.IPv4 Initial Set up
Define two TCP/IP settings for the NMC before the NMC can operate on the network:
IP address of the NMC.
IP address of the default gateway (only needed if you are going off segment).
Do not use the loopback address (127.0.0.1) as the default gateway. Doing so disables the card. Then log on using a serial connection and reset the TCP/IP settings to the defaults.
ReferenceFor detailed information on how to use a DHCP server to configure the TCP/IP settings at an NMC, see the "TCP/IP and Communication Settings" section in the, "Administration:Network Features" chapter of this manual.IPv6 Initial Set up
IPv6 network configuration provides flexibility to accommodate the user requirements. Use the device "IP Configuration Wizard" for initial setup.Network Management Features
These applications and utilities work with a UPS that connects to the network through an NMC.Network Shutdown Utility - Provide unattended remote graceful shutdown of computers that are connected to UPSsManagement Information Base (MIB) with a standard MIB browser - Perform SNMP, SETs, and GETs and use SNMP trapsDevice IP Configuration Wizard - Configure the basic settings of one or more NMCs over the networkSecurity Wizard - Create components needed for high security for the NMC when you are using Secure Sockets Layer (SSL) and related protocols and encryption routinesInternal Management Features
Overview
Use the web interface or the command-line interface to view the status of the UPS and manage the UPS and the NMC. You can also use SNMP to monitor the status of the UPS.ReferenceFor more information about the internal user interfaces, see the, "Web Interface" chapter and the, "Command Line Interface" chapter in this manual. See the "SNMP" section in the, "Administration:Network Features" chapter for information about how SNMP access to the NMC is controlled.Access Priority for Logging On
Only one user at a time can log on to the management card. The priority for