COIL AS-HEATER 1413024 - Caterpillar

Illustration 10 g03181197
(6) 277-7497 Hose As
Unscrew and remove the 277-7497 Hose As from the D3 connection (4) to the hydraulic block (3) .
Illustration 11 g03183102
Unscrew and remove the hose from the A7 connection (5) from the block (3) .
Illustration 12 g03183156
(7) 6V-9837 Swivel Tee
Mount to the A7 connection (5) of the hydraulic block, the 6V-9837 Swivel Tee (7) with 6V-8398 O-Ring Seals (8) provided into the kit.
Illustration 13 g03183218
(9) 8C-8989 Elbow
Mount the 45° 8C-8989 Elbow (9), to the swivel tee (7) with 6V-8398 O-Ring Seals (8) provided into the kit.
Illustration 14 g03183277
(10) Free tee swivel terminal
Connect the hose 272-0810 Hose As to the free tee swivel terminal (10) .
Illustration 15 g03183436
(11) Location of the elbow 45? swivel
Connect 277-7497 Hose As (5) (which comes from D3 connection of the block), to the elbow 45° swivel (11) .
Illustration 16 g03185581
Ensure that 277-7497 Hose As (5) , 45° 8C-8989 Elbow (9), or any other component related to the new routing, does not come in contact with the block or other existing parts.
Illustration 17 g03185737
(12) 9S-4191 O-Ring Plug
Close the D3 connection by using the 9S-4191 O-Ring Plug (12), with the related 3J-1907 O-Ring Seal (13) .
Illustration 18 g03185916
Replace all 16 of the 360-9134 Dampers (14) .
Illustration 19 g03185963
(15) Broken motor seal
Identify the broken motor seal (15) (vibratory or tamper).
Remove the broken motor seal (15) .
Replace the seal on the motor shaft with 421-5596 Lip Type Seal (16). In order to preserve the seal from damage follow these steps.
Cover the splines of the shaft with electrical tape or something similar.
Lubricate this surface with grease.
Slide the 421-5596 Lip Type Seal (16) over the tape.
Illustration 20 g03181097
Mount both covers (2) for the screed platform in order to restore the machine configuration.