CONNECTOR 3727415 - Caterpillar

Removal Procedure
Start By:
Remove the front housing.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00637281
Remove two bolts and washers (1) in order to remove bracket (2).
Remove bolt (3) and the washer.
Remove bracket (2), the clip, and the sensor as a unit.
Install bolts and washers (1) and (3) into cover (4).
Illustration 2 g00637310
Remove clip (5).
Loosen locknut (6). Unscrew sensor (7) from bracket (2). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g00637339
Install bracket (1).
Screw sensor (2) into bracket (1) until the sensor contacts a tooth of crankshaft gear (3). Then unscrew the sensor for 1/2 1/10 of a turn (180 36 degrees). The correct dimension (A) for the gap between the sensor and the tooth of the crankshaft gear is 0.70 0.14 mm (0.0276 0.0055 inch).
Make sure that sensor (2) does not move when locknut (4) is tightened. Tighten locknut (4) to a torque of 45 7 N m (33 5 lb ft).
Illustration 4 g00637379
Install connector (5) into clip (6). Install the clip. End By:
Install the front housing.