CORK 6I6441 - Caterpillar

Illustration 17 g02658859
Optional Right Joystick (3-Button, Trigger Switch) and Schematic Symbol
(1) One Touch Low Idle Switch (SW-3)
(2) One Touch Low Idle Switch (SW-3) Connections Note: SW-2 is a trigger switch and is not shown in Illustrations 16 and 17.The one touch low idle switch (1) is located on the top or on the front of the right joystick (see Illustrations 15, 16, and 17). The one touch low idle switch will automatically reduce engine speed to 1150 RPM. Both the right and the left joysticks must be in the neutral position before the engine speed is reduced.Horn Switch
Illustration 18 g03230240
Left Joystick (2-button, Slide, Trigger Switch)
(1) Horn Switch (SW-3)
(2) Horn Switch (SW-3) Connections When horn switch is depressed, power is sent to the horn relay. The horn relay sends power to the horn.Right Side Control Panel
Note: Your machine may not be equipped with all of the controls that are described in this topic.
Illustration 19 g02774877
Right Side Control Panel
(1) Engine speed control
(2) Power mode
(3) Travel speed control
(4) Automatic engine speed control (AEC)
(5) Travel alarm switch
(6) Work tool control
(7) Heavy lift control (Not Equipped)
(8) Window washer
(9) Window wiper
(10) Light switch
(11) Rear view camera
(12) Quick coupler control
(13) Empty
(14) Radio mute
(15) Lower window wiper
(16) Lower window washer
(17A) Boom pressure control switch
(17B) Fine swing control
(18) Overload warning device (1)" Engine Speed Dial Control Switch" This switch is used for the selection of the engine speed. The position of the engine speed dial is indicated on the operator monitor. Engine speed dial (3) is a 10 - position switch. The selected position is displayed on operator monitor. (2)" Power Mode" This switch is used for the selection of the power mode. The power mode can be changed from high hydraulic power to standard power to economy mode. The monitor will indicate the mode that is selected.
Illustration 20 g02160606
High Power Mode
Illustration 21 g02160607
Standard Power Mode
Illustration 22 g02160612
Economy Power Mode
(3)" Travel Speed Control" This switch is used to select the travel speed of the machine. When the LOW SPEED position is selected, the "turtle" indicator will illuminate. When AUTO position is selected, the "rabbit" indicator will illuminate. When the engine start switch is on, the travel speed control switch is always set at the LOW SPEED position. (4)" Automatic Engine Speed Control" This switch is used for selection of the Automatic Engine Speed Control (AEC). The AEC system operates in three modes. The AEC automatically reduces engine speed when the machine is inactive. The AEC system will be inoperable while the backup switch of the electronic controller system is in the MAN position. (5)" Travel Alarm Cancel Switch" This switch is used to stop the travel alarm from sounding. Press the switch in order to stop the alarm. The indicator lamp will turn on. The travel alarm will sound when the travel lever or the travel pedal is activated. (6)" Work Tool Control" This switch is used for tool selection on machines with the optional tool control system. When this switch is activated, a tool selection menu is displayed on the monitor and