DRIVE AS-FAN 3219971 - Caterpillar

Illustration 38 g01451665
Attach Tooling (B), Tooling (C), and a suitable lifting device to housing assembly (11). The weight of housing assembly (11) is approximately 680 kg (1500 lb). Install housing assembly (11) onto the torque converter. Install bolts (10).
Illustration 39 g01450330
Lubricate bearing cones (16) with the oil that is being sealed. Install bearing cones (16) onto idler gear (15).
Illustration 40 g01450328
Use two people in order to install idler gear (15) and the shim pack. The weight of idler gear (15) is approximately 36 kg (80 lb).
Illustration 41 g01451687
Lower the temperature of bearing cup (12). Install bearing cup (12) into pump adapter (5).
Illustration 42 g01451688
Attach Tooling (B) and a suitable lifting device to pump adapter (5). The weight of pump adapter (5) is approximately 50 kg (110 lb). Install pump adapter (5) and bolts (6) onto housing assembly (11).
Repeat Steps 52 through 58 in order to adjust bearing end play.
Illustration 43 g01453037
Illustration 44 g01451688
Use Tooling (B) and the suitable lifting device in order to remove pump adapter (5) from housing assembly (11).
Install lip seal (13) and O-ring seals (14) to pump adapter (5). Use Tooling (B) and the suitable lifting device in order to install pump adapter (5) onto housing assembly (11). Install bolts (6).
Illustration 45 g01451697
Install the O-ring seals and manifold (8). Install bolts (7).
Install the O-ring seal and orifice plug (9) (not shown) on housing assembly (11).
Illustration 46 g00356876
Install seal (4) on yoke (1).
Illustration 47 g01450165
Install yoke (1), retainer (3), and bolt (2). Tighten bolt (2) to a torque of 240 25 N m (177 18 lb ft). Note: The following Steps will verify the proper assembly of the torque converter. This should be done before the torque converter is installed into the machine.
Illustration 48 g01452543
Apply air pressure to port (108). The air should flow freely through the torque converter. A blockage exists when the air nozzle is pushed backward. The torque converter will need to be repaired before installation into the machine.
Illustration 49 g01452547
For torque converters with a lockup clutch, apply air pressure to port (109). The lockup clutch should engage. A blockage is present when the lockup clutch does not engage. The torque converter will need to be repaired before installation into the machine. End By:
Install the piston pump. Refer to