ENGINE AR-COMPLETE 1331049 - Caterpillar

Illustration 7 g01134121
The following screen should appear once program "flashing" is complete.
Illustration 8 g01134122
Click "OK".
The "Connect" icon should change from being grayed out to active. Click the "Connect" icon on the tool bar in order to return to Cat ET. Refer to the arrow in Illustration 9. (You may also select "File" on the menu bar, then click "Connect" from the drop-down menu.) PL321SR System
Flash Program the PL121 Radio Module
WinFlash is used in order to load the software. The following steps explain the process in order to flash program the PL300.
Select the "ECM Summary"Screen.
Illustration 9 g01133998
PL300 "System ECM Summary" Screen
In a PL321 system, in order to flash the PL121SR (radio) by using the PL300 ECM, select "Service" menu bar and then select "Subsystem Module Programming".
Illustration 10 g01134106
"Subsystem Module Programming" Screen
The "Subsystem Module Programming" screen should appear.
Illustration 11 g01134107
Click on "Submodule".
Illustration 12 g01134109
Click on the correct flash file for the PL121SR to load.
Illustration 13 g01134110
"File Select" Screen
Click the "Begin Progamming" button that is located on lower right side of screen.
Illustration 14 g01134111
The following screen should appear while "flashing" is in progress.
Illustration 15 g01134112
The following screen should appear once program "flashing" is complete.
Illustration 16 g01134113
Click "OK" in order to acknowledge.Flash the PL300 ECM
In order to flash the PL300 ECM in a PL321 system, select the ECM.
Illustration 17 g01134819
Select the file.
Illustration 18 g01134820
Click "Begin Flash"
Illustration 19 g01134821
The following screen should appear while the program is being loaded.
Illustration 20 g01134822