ENGINE AR-CORE 1429947 - Caterpillar

Illustration 1. Spray bar support assembly. To adapt the cocoa mat to existing water spray systems, use the following procedure.
Illustration 2. Detail A. Dimension (X). Dimension (Y). Dimension (Z). Cocoa mat (1).Dimension (X) = 9.0 mm (.35 in) diameter.
Dimension (Y) = 17.0 3.0 mm (.67 .12 in).
Dimension (Z) = 208 mm 3 mm (8.2 .1 in)
1. Drill four holes (two for each spray bar) in the spray bar support assembly, using dimensions (X), (Y) and (Z).
Illustration 3. Section B-B. Cocoa mat (1). Plate (2). Bolt (3). Nut (4). Washer (5). Plunger (6). Socket (7). Washer (8). Bolt (9). Clip (10).2. Fasten (each) cocoa mat (1), plate (2) and three clips (10) with six bolts (3), washers (5) and nuts (4) as shown in Illustrations 2 and 3. Assemble bolts (3) with 6.0 mm (.24 in) of thread extended above nut (4).3. Fasten four sockets (7) with bolts (9) and washers (8), using the holes that were drilled in Step 1. Use the location of socket (7) to locate plunger (6).4. Fasten four plungers (6) with bolts (3), washers (5) and nuts (4).5. When the spray system is not in use, rotate the cocoa mat and fasten in the up position by pushing plunger (6) into socket (7).