ENGINE AR-COMPLETE 1692356 - Caterpillar

Table 2
Optional Tools (1)    
Tool    Part
Number    Description    Qty    
K     8T-0860     Pressure Gauge
0 to 40000 kPa (0 to 5800 psi)     1    
L     6V-3989     Fitting     1    
M     6V-4143     Quick Connect Coupler     2    
N     177-7860     Hose As     1    
( 1 ) The optional tools can be used in place of the digital pressure measurement tools which are specified in the required tool list.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g01162713
Move propulsion lever (2) to the NEUTRAL position.
Rotate speed dial (3) to the MINIMUM position.
Move parking brake switch (4) to the ON position.
Move screed lower switch (6) to the DOWN position. Lower the screed to the ground.
Move throttle control switch (5) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Move engine start switch (1) to the OFF position after the engine reaches low idle.
Illustration 2 g01162718
Move key switch (7) to the OFF position.
Install Tool (F) and Tool (H) on Tool (D) . Use the appropriate O-ring seals that are Tool (E) and Tool (G) when Tool (F) and Tool (H) are installed.
Illustration 3 g01245331
Remove the fitting from bulkhead connector (8) . This connector is located at the rear of the tractor. Connect Tool (D) to the bulkhead connector.
Install Tool (C) on Tool (D) . Use Tool (B) in order to connect Tool (C) to Tool (A) .
Move key switch (7) to the ON position. Move engine start switch (1) to the START position. Release the engine start switch after the engine starts.
Move throttle control switch (5) to the HIGH IDLE position. Hold the switch in this position for less than 1 second. The engine speed will increase to 2310 rpm.
Monitor the hydraulic oil temperature with Tool (J) . Operate the machine until the oil temperature reaches 43° 5.6°C (110° 10°F).
Illustration 4 g01245334
Move vibrator switch (9) on the instrument panel to the ON position.
Illustration 5 g01245348
Move vibrator switch (10) on the right screed control panel to the ON position.
Move propulsion lever (2) to the full FORWARD position.
Move parking brake switch (4) to the OFF position.
Rotate speed dial (3) until the machine starts to move.
Read the pressure on Tool (A) . The pressure should be 10859 1034 kPa (1575 150 psi).Note: A delay of approximately 0.5 seconds will occur before the vibrator will start and the pressure will register on Tool (A) .
Rotate speed dial (3) into the MINIMUM position.
Move propulsion lever (2) to the NEUTRAL position.
Move parking brake switch (4) to the ON position.
Stop the engine. (Perform Step 6 through Step 8.) If the pressure is inside the specified range, go to Step 28. If the pressure is outside the specified range, adjust the pressure with the following procedure.
Open the access panel on the left side of the operator platform.
Illustration 6 g01245351
Loosen locknut (12) . In order to increase pressure, rotate adjustment screw (11) clockwise. In order to decrease pressure, rotate