1695091 ENGINE AR-COMPLETE Caterpillar parts
3406E
Rating:
Alternative (cross code) number:
CA1695091
169-5091
1695091
CA1695091
169-5091
1695091
TRUCK ENGINE,
Related part:
1695091
SHORT BLOCK
10R1511
R
1695091
LONG BLOCK M
10R1512
R
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$418.99
10 Feb 2022
US: Telina
Delixike Compatible with Briggs Compatible with Stratton 1501981MA Assembly Auger, 22
Delixike Part number 1501981 and/or 1501981MA 1501981ma. || Compatible With Craftsman: 536881510 Snowblower 536881501 22" Snowblower 536881500 Snowblower Gas. || Compatible With Simplicity: 1695090 5022E, 22In Single Stage Snowblower 1695091 5022Ex, 22In Single Stage Snow. || Please wear gloves to protect your hands during installation.
Delixike Part number 1501981 and/or 1501981MA 1501981ma. || Compatible With Craftsman: 536881510 Snowblower 536881501 22" Snowblower 536881500 Snowblower Gas. || Compatible With Simplicity: 1695090 5022E, 22In Single Stage Snowblower 1695091 5022Ex, 22In Single Stage Snow. || Please wear gloves to protect your hands during installation.
For full view, you need register
Compatible equipment models: 1695091:
Information:
Illustration 1 g02901576
Place a suitable container under the drain hose. Open the drain valve (1).
Drain the engine oil completely.
Close the drain valve.
Remove filter element (2). Discard the used filter element.
Clean the filter housing base. All of the old filter seal must be removed from the filter housing base.
Apply a thin coat of engine oil to the seal of the new filter element. Note: There are rotation index marks on each engine oil filter that are spaced 90 degrees or 1/4 turn away from each other. When you tighten oil filters, use the rotation index marks as a guide.
Install the engine oil filter hand tight until the seals of the engine oil filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base.
Tighten the filter according to the instructions that are printed on the filter. Use the index marks as a guide.
Illustration 2 g02901579
Remove oil fill cap (3). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)". Clean the oil filler cap and install the oil filler cap.
Illustration 3 g02448697
Before you start the engine, check the oil level on oil level gauge (4). The oil level must be between the "L" mark and the "H" mark on the oil level gauge.
Start the engine. Run the engine for two minutes. Inspect the machine for leaks. Stop the machine.
Wait for ten minutes in order to allow the oil to drain back into the crankcase. Check the oil level. Maintain the oil level between the "L" mark and the "H" mark on the oil level gauge.
Close the engine compartment.