ENGINE AR 2199507 - Caterpillar

Installation Procedure
Inside Cab
Illustration 1 g03580477
(1) Side cover
Remove side cover (1).
Illustration 2 g03580609
(A) 339-2675 Rocker Switch
Install rocker switch (A).
Connect rocker switch (A) to the five pin connector of the standard cab harness. 607-PK(Pink), 199-OR(Orange), 607-PK(Pink), 200-BK(Black) Fuse Base
Illustration 3 g03580759
(2) Fuse base
Illustration 4 g03580776
(B) 161-3128 Relay
(3) Priming pump (for 336E and 349E Excavators)
(4) Hydraulic lock solenoid
(5) Cab lamp
(6) Neutral start
(7) Boom lamp
(8) Chassis lamp
(9) Horn
(10) Lifting pump (for 312E through 329E Excavators)
Install relay (B) on fuse base (2). Refer to Illustration 4. Cab Rear Panel
Illustration 5 g03580876
(11) Connector
(12) Standard chassis harness
(13) Breaker box
Disconnect connector (11).
Illustration 6 g03580877
(C) 360-6274 Lighting Harness As
(D) 3S-2093 Cable Strap
(E) 116-0118 Clip
(F) 7X-2621 Bolt
(G) 8T-4121 Hard Washer
Route connector (11) through clip (E) and connect to lighting harness assembly (C). Secure lighting harness (C) using cable straps (D). Attach clip (E) the rear panel of the cab using bolt (F) and washer (G).
Illustration 7 g03581043
(G) 8T-4121 Hard Washer
(H) 289-7416 Warning Light Gp
(J) 333-3970 Grommet
(K) 333-3994 Cover
(L) 333-4007 Plate
(M) 356-8051 Plate As
(N) 8T-4136 Bolt
Connect lighting harness (C) to warning light assembly (H). Mount warning light (H) using cover (K), plate (L), and plate assembly (M). Mount plate assembly (M) to the rear cab panel using washers (G) and bolts (N). Refer to Illustration 7.