ENGINE AR-CORE 2978106 - Caterpillar

Adjustment Procedure
1. Loosen nut (4).2. Remove cotter pin and pin that connects the rod end to lever (6).3. With lever (6) against bumper (5), make an adjustment of rod (2) so that distance (A) between the centerline of the handles on rod (2) and the face of the dash is ... 106.9 6.4 mm (4.20 .25 in)4. Install pin and cotter pin that connects rod (2) to lever (6).5. Tighten nut (4) to a torque of ... 100 15 N m (75 10 lb ft)6. Remove cotter pins and pins from rod (7).7. Make an adjustment to rod (7) so that distance (D) between the centerline of the pins is ... 549.9 1.5 mm (21.65 .06 in)8. Install the pins and cotter pins in the ends of rod (7).9. Tighten nut (8) to a torque of ... 12 4 N m (9 3 lb ft)10. Loosen nut (13) on rod (12).11. Remove cotter pin and pin. Make an adjustment to the length of rod (12) so that roller (11) is against stem (10).12. Install pin and cotter pin and tighten nut (13) to a torque of ... 12 4 N m (9 3 lb ft)13. Loosen set screw on collar (3).14. Pull rod (2) out until valve stems (10) are fully actuated. With rod (2) in this position, move collar (3) against roller (1) and tighten the set screw. The set screw must be in a down position when tightened. Correct adjustment of the control linkage will push stem (10) in a distance (C) of .. 13.5 to 14.0 mm (.53 to .55 in)Adjustment Of Steering Clutch Yoke Assembly
1. Remove cotter pin and pin and remove rod assembly (16).2. Loosen nut (15). Make an adjustment to the rod so that distance (E) between the flat surface of nut (14) and center of hole in rod (16) is ... 88.9 0.8 mm (3.50 .03 in)3. Tighten locknut (15) to a torque of ... 100 15 N m (75 10 lb ft)4. Install pin and cotter pin.5. Loosen nut (18).6. Make an adjustment to the length of bolt (17) so that distance (F) between the centerline of pin (19) and the head of bolt (17) is ... 38.1 0.8 mm (1.50 .03 in)7. Tighten nut (18).8. Loosen locknut (22).9. Make an adjustment to nut (21) until the edge of bellcrank (20) is in alignment with the centerline of the hole in the cover assembly (as seen in Section X-X).10. Tighten locknut (22) to a torque of ... 100 15 N m (75 10 lb ft)