FILTER-OIL 1440832 - Caterpillar

Illustration 1 g00103219
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Movement of some heavy components requires a hoist and lifting fixtures in order to obtain proper balance and safety. Position the hoist for a level lift of the transmission and use an adjustable lfting beam to lift the transmission. Spreader bar widths should be sufficient for preenting contact with the transmisson. All supporting members (chains and cables) should be parallel to each other and perpendicular to the top of the object that is being lifted. Alterations to lifting eyes or fixtures will make them obsolete. Use properly rated chains, cables, and slings.
Illustration 2 g02992996
CX48-p2300 Transmission
(1) Lifting Points (Four)
(A) Two customer mounting/lifting holes, 3/4-2B Thd x 1.75 inch deep (34 mm), if equipped
The weight of the CX48-P2300 Transmission and engine coupling with a dry sump is approximately 1757 kg (3873 lb).
The lift points indicated in Illustration 2 are the only approved lifting points for the fully assembled transmission.
Care must be taken when lifting to avoid damaging the following components that are mounted externally on the transmission: ECM, solenoids, wire harness, hoses, and sensors.Tying Down
The rear transmission lifitng eyes should be used to tie down the rear of the CX48 Petroleum Transmission. The front of the CX48 Petroleum Transmission can be tied down by using an approved strap or chain over the torque converter housing.