FRAME AS 1516778 - Caterpillar

Section A-A
Section B-B
Section C-C
Section D-D
Section E-E All bores must be free of paint. Bore surfaces must be free of paint and grease prior to assembly of bearings. Coat all bores for pins with lubricant including bucket and cylinder pin bores.(1) Torque pin retainer bolt to ... 325 40 N m (240 30 lb ft)(2) 5I3299 Pin Assembly: Outside diameter ... 79.850 0.025 mm (3.1437 .0010 in)Plating thickness ... 0.005 mm (.0002 in) minimum(3) Bucket cylinder pin bore diameter ... 80.037 0.037 mm (3.1511 .0015 in)(4) Shim as required to adjust lateral clearance to ... 1.6 mm (.06 in) maximum: 930083 Shim thickness ... 1.0 mm (.04 in)7Y2498 Shim thickness ... 1.6 mm (.06 in)930115 Shim thickness ... 2.0 mm (.08 in)(5) 7Y3553 Bearing: Outside diameter ... 106.200 0.013 mm (4.1811 .0005 in)Inside diameter ... 90.27 0.02 mm (3.554 .001 in)Bearings must be assembled so that thrust groove (6) is to the inside of the boss and one groove is at the top of the bore.Install bearing in bore (two places) ... 9.5 0.8 mm (.37 .03 in)(7) Lubricate sealing lips lightly with lubricant being sealed.(8) 7Y3551 Bearing: Outside diameter ... 85.160 0.013 (3.3528 .0005 in)Inside diameter ... 70.23 0.02 mm (2.765 .001 in)Install bearing in bore (two places) ... 7.5 0.8 mm (.30 .03 in)(9) 1035354 Bearing: Outside diameter ... 130.240 0.013 mm (5.1276 .0005 in)Inside diameter ... 110.30 0.02 mm (4.342 .001 in)Install bearing in bore (two places) ... 9.5 0.8 mm (.37 .03 in)(10) 1132963 Pin Assembly: Outside diameter ... 89.850 0.025 mm (3.5374 .0010 in)Plating thickness ... 0.005 mm (.0002 in) minimum(11) Stick cylinder pin bore diameter ... 90.043 0.043 mm (3.5450 .0017 in)(12) Shim as required to adjust lateral clearance to ... 1.6 mm (.06 in) maximum: 930084 Shim thickness ... 1.0 mm