HOSE AS 2501133 - Caterpillar

1. Disconnect two tube assemblies (2) and two hoses (1) from transmission relief valve (3).2. Disconnect electrical connector (5) going to the sensor.3. Remove the three bolts (4) that hold transmission relief valve (3) on the transmission, and remove the transmission relief valve.4. Remove the eight O-ring seals from the transmission relief valve. The following steps are for installation of the transmission relief valve.5. Install the eight O-ring seals on transmission relief valve (3).6. Position the transmission relief valve on the transmission, and install the three bolts (4) that hold it in place. Tighten the bolts to a torque of 48 4 N m (35 3 lb ft).7. Connect electrical connector (5) to the sensor.8. Connect tube assemblies (2) and hoses (1) to transmission relief valve (3).End By:a. install cab **This operation is in the Machine Systems Disassembly & Assembly module, Form No. SENR9443.Disassemble & Assemble Transmission Relief Valve
Start By:a. remove transmission relief valve 1. Remove sensor (1) from valve body (2).2. Remove three bolts (3), cover (5), spool (7), slug (8) and spool (12) from the valve body.3. Remove two O-ring seals (6) from cover (5).4. Remove three bolts (4), cover (11), spool (9), spring (10), piston (16), three spacers (15) and springs (13) and (14) from valve body (2).5. Remove the four O-ring seals from cover (11). 6. Remove ring (17), retainer (18), spring (19) and check (20) from spool (12). 7. Remove plug (23), spring (22) and valve (21) from valve body (2). Remove the O-ring seal from plug (23).8. Remove plug (24), retainer (25), spring (26) and poppet (27) from the valve body.9. Remove the O-ring seal from plug (24). Remove the washers from inside retainer (25).10. Remove plug (31), retainer (30), spring (29) and poppet (28) from valve body (2).11. Remove the O-ring seal from plug (31). Remove the washers from inside retainer (30). The following steps are for assembly of the transmission relief valve.12. Check the condition of the O-ring seals used in the transmission relief valve. If any of the seals are worn or damaged, use new part for replacement.13. Install the O-ring seal on plug (31). Install the washers in retainer (30).14. Install poppet (28), spring (29), retainer (30) and plug (31) in valve body (2).15. Install the O-ring seal on plug (24). Install the washers in retainer (25).16. Install poppet (27), spring (26), retainer (25) and plug (24) in the valve body.17. Install the O-ring seal on plug (23). Install valve (21), spring (22) and plug (23) in valve body (2).18. Install check (20), spring (19), retainer (18) and ring (17) in spool (12).19. Install the four O-ring seals on cover (11).20. Install springs (13) and (14), three spacers (15), piston (16), spool (9), spring (10), cover (11) and bolts (4) in valve body (2). Tighten the bolts to a torque of 30 7 N m (22 5 lb ft).21. Install two O-ring seals (6) on cover (5).22. Position slug (8) in spool (7). Install