HOSE AS 3870166 - Caterpillar

Illustration 1 g03326191
Schematic of the action alarm
The CID 0271 diagnostic code is associated with the action alarm. The FMI 06 means that the Advisor module has determined that the current of the alarm circuit is above normal or grounded to the circuit.The possible causes of this diagnostic code are listed below:
The energize circuit of the alarm is shorted to ground.
The alarm has failed.
The display module has failed. This condition is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0271 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.Test Step 1. CHECK THE ALARM
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the alarm with the active diagnostic code from the machine harness for the display module. Expected Result:The CID 0271 FMI 06 diagnostic code changes to a CID 0271 FMI 06 diagnostic code when the alarm is disconnected.Results:
YES - The CID 0271 FMI 06 diagnostic code changes to a CID 0271 FMI 06 diagnostic code when the alarm is disconnected. The circuit is correct.Repair: The alarm has failed. Repeat this test "CHECK THE ALARM" in order to verify the failure of the alarm. Replace the alarm.STOP
NO - The CID 0271 FMI 06 diagnostic code remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE ALARM FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
The alarm remains disconnected from the machine harness.
Disconnect the machine harness connector for the action alarm from the display module.
At the machine harness connector for the display module, measure the resistance from the signal contact IC-8 (wire 410-WH(White)) to all contacts that are used in the machine harness connectors for the display module. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between IC-8 (wire 410-WH(White)) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Inspect the harness connectors and clean the contacts of the harness connectors that are in the affected circuit. Check the wires for damage to the insulation that can be caused by excessive heat or chafing.
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the switch circuit.
Reconnect all harness connectors. Make sure that the connectors are fully seated and the clips for each connector are fastened.
Turn the disconnect switch and the key start switch to the ON position.
Enter service mode