HUB-IDLER GEAR 3240444 - Caterpillar

CAN Annunciator
Illustration 1 g02278719The EMCP CAN annunciator serves to display system alarm conditions and status indications. The CAN annunciator has been designed for use on the EMCP 4 accessory CAN data link. The CAN annunciator may be used in either local or remote applications, providing customers with enhanced site flexibility.In local application, the CAN annunciator may be mounted on the package generator set with the EMCP 4 to provide a complete package-mounted monitoring solution.The annunciator may also be mounted separately from the generator set to provide remote indication of system operating and alarm conditions.A maximum of four CAN annunciators can be mounted locally or remotely and connected to the accessory CAN 2 data link.Features
Sixteen (16) LED pairs for annunciation of up to 32 system events
An additional pair of LEDs provides status indication of the CAN data link connection
Can annunciate alarm conditions received from any module on the CAN data link
Alarm horn with lamp test and alarm acknowledge push buttons
Can be mounted either locally on the package generator set or remotely (up to 244 m (800 ft)) on the accessory CAN data linkSpecifications
Electrical Specifications
Control power 12 VDC and 24 VDC nominal (9 VDC to 32 VDC acceptable)
Over voltage capability is 80 VDC for 2 minutes at 70° C (158° F)
Reverse voltage capability is –32 VDC for 1 hour at 70° C (158° F)
Single, 6-pin connector provides both power and communicationEnvironmental Specifications
Operating temperature −40° C (−40° F) to 70° C (158° F).
Relative humidity 90%, non-condensing, 30° C (86° F) to 60° C (140° F).
Failure point of 85° C (185° F). If the ambient temperature exceeds 85° C (185° F), the device would not be expected to return to proper operation.Network Communication Interface
Incorporates a communications port, able to operate on the EMCP 4 accessory CAN data link
Node address can be configured automatically
Optical isolation is provided for the CAN line
Module operates normally with loss of communication link, retaining configured set points in non-volatile memory
Configuration and firmware updates are accomplished with Cat ET over the CAN 2 networkWiring
The back of the CAN annunciator module contains an eight terminal screw terminal block. Attached to the block is a six pin Deutsche adapter. The pin outs for both are shown in Illustration 2, Illustration 3 and Table 1.
Illustration 2 g02279433
(1) PWR+ (RED)
(2) PWR- (BLK)
(3) N/C
(4) N/C
(5) CAN L (YEL)
(6) CAN H (GRN)
Illustration 3 g02280193
Refer to Table 1 for a pin out description
Table 1
Annunciator Terminal Block Pin Configuration
Terminal # Function Description
1 PWR- - Battery Input
2 PWR+ + Battery Input, also connects to Horn (+)
3 N/C Not Connected
4 CAN 2 High CAN Datalink HI
5 CAN 2 Low CAN Datalink LOW
6 Lamp Test Lamp Test
7 Alarm Acknowledge Alarm Acknowledge
8 Horn Driver Connects to negative terminal of Horn LED Colors
Each pair of LEDs on the annunciator consists of two of the following three colors: green, amber, and red. The colors allow for custom configuration of status, warning, and shutdown conditions. The available colors and combinations are listed in Table 2:
Table 2
LED Colors
Row LED 1 LED 2
1 Red Amber
2 Red Amber
3 Red Amber
4