INJECTOR GP-FUEL 3784609 - Caterpillar

Minimum bend radius for the cable is 20.0 mm (0.77 inch)
Diameter of the cable is 10.0 mm (0.39 inch)Note: Refer to Special Instruction, REHS9101, "Machine Guidance Upgrades For Cat ® Grade Control Hydraulic Excavators" for further sensor cable information.Reference Section
Reference: Special Instruction, REHS9101, "Machine Guidance Upgrades For Cat ® Grade Control Hydraulic Excavators"Installation Procedure
Illustration 1 g06169839
Right-hand side view of DCT bucket
(A) Sensor mounting plate
(B) Boss for sensor cable mounting
Illustration 2 g06170755
(C) Grade control sensor
(5) 8T-4171 Bolt
(6) 9X-8256 Washer
Install grade control sensor (C) on the sensor mounting plate (A) using four bolts (5) and four washers (6).
Illustration 3 g06170343
(C) Grade control sensor
(D) Sensor cable
(1) 204-8000 Cable Tie Mounting
(2) 204-2281 Cable Strap
(3) 7X-2621 Bolt
(4) 8T-4121 Hard Washer
Illustration 4 g06170344
(B) Boss
(D) Sensor cable
(1) 204-8000 Cable Tie Mounting
(2) 204-2281 Cable Strap
(3) 7X-2621 Bolt
(4) 8T-4121 Hard Washer
Connect one end of the sensor cable (D) to the grade control sensor (C). Secure sensor cable with boss (B) using cable tie mounting (1), cable strap (2), bolt (3), and hard washer (4). Refer Table 2 to select sensor cable length for the respective linkage/interface.
Illustration 5 g06169847
Left-hand side view of DCT bucket
Run the sensor cable from the right-hand side of the bucket to the left-hand side of bucket using two bosses (B) as shown in Illustration 5.
Illustration 6 g06170345
(B) Boss
(D) Sensor cable
(1) 204-8000 Cable Tie Mounting
(2) 204-2281 Cable Strap
(3) 7X-2621 Bolt
(4) 8T-4121 Hard Washer
Illustration 7 g06170761
(C) Grade control sensor
(B) Boss
(D) Sensor cable
(1) 204-8000 Cable Tie Mounting
(2) 204-2281 Cable Strap
(3) 7X-2621 Bolt
(4) 8T-4121 Hard Washer
(5) 8T-4171 Bolt
(6) 9X-8256 Washer
Secure sensor cable (D) with two bosses (B) using two cable tie mountings (1), two cable straps (2), two bolts (3), and two hard washers (4).
Route and connect sensor cable (D) to the tilt bucket connector. Ensure free movement of the tilt bucket through its entire range without straining the cable.
Select the proper worktool and calibrate the tilt bucket sensor.