KIT-PLUNGER 9V5160 - Caterpillar

3508 (23Z, 70Z),
3512 (24Z, 67Z),
3516 (4XF, 5SJ, 25Z, 73Z) Generator Set Engines;
3508 (95Y, 68Z),
3512 (1LM, 49Y, 65Z),
3516 (27Z, 71Z) Industrial Engines;
3508 (6TJ),
3512 (2WK),
3516 (9KF) Locomotive Engines;
3508 (96Y, 69Z),
3512 (50Y, 66Z),
3516 (4MJ, 29Z, 72Z) Marine Engines;
3508 (97Y),
3512 (51Y),
3516 (28Z) Vehicular EnginesSUPPLEMENT: 10/01/96Engine News; August 1996; Page 8; "New Lifters Improve Roller-To-Camshaft Contact And New Bridges Provide Commonality With 3500B Engines" Under the "Adaptable To:" section, the second sentence of the second paragraph should read "The new 129-4181 Bridge Assembly replaces the former 8N-7292 Bridge Assembly."
--------------- END SUPPLEMENT ---------------Description of Change: Improvements have been made to the lifter assemblies and bridge assemblies of the valve mechanism groups in the above 3500 Engines. Lifter Assembly
The new lifter assemblies in the valve mechanism groups improve roller-to-camshaft contact. As the result, premature pitting on the camshaft is eliminated. The location of the lifter is shown in Illustration 1.
Illustration 1. Typical Valve Mechanism Group: (1) Bridge Assembly. (2) Lifter Assembly.
Illustration 2. Former 4P-1827 Lifter Assembly: (3) Previous slot location. (4) Flat spot caused by slot.
Illustration 3. New 132-9439 Lifter Assembly: (5) New slot location (elimination of the flat spot on the upper locating arm). (6) Elimination of the sharp edge between the rolling surface and the corner radius.The body of the lifters was improved through the elimination of the flat spot on the upper locating arm. This was accomplished by moving the slot further down the locating arm. The roller was improved by the elimination of the sharp edge between the rolling surface and the corner radius. Refer to Illustration 3.
Bridge Assembly
The new bridge assemblies of 3500 Engines provide commonality with 3500 "B" series Engines. The location of the new bridge is shown in Illustration 1.
Adaptable To: Improvements to the lifter assemblies and bridge assemblies have been made within 4W-1035 and 7E-5314 Valve Mechanism Groups. New 132-9439 Lifter Assembly replace former 4P-1827 Lifter Assembly. New 8N-7292 Bridge Assembly replace former 129-4181 Bridge Assembly. These engine improvements to lifters and bridges are effective with the serial numbers listed in the following chart.