LEVER 5J7671 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 187-2718 Filter Wrench 1
ZZ 6V-9511 Plug 2
6V-9832 Cap As 2 Start By:
Remove the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Remove and Install". Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01068880
Disconnect harness assembly (1).
Disconnect hose assemblies (3) from filter base (4).
Use Tooling (A) and remove filter (5) from filter base (4).
Remove bolts (2) and remove filter base (4) from the machine. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 187-2718 Filter Wrench 1
Illustration 2 g01068880
Install filter base (4) and bolts (2).
Use Tooling (A) and install filter (5) on filter base (4). Refer to the Operation and Maintenance Manual for the correct procedure.
Connect hose assemblies (3) on filter base (4).
Connect harness assembly (1). End By:
Install the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Remove and Install".