MAST AS OUT&IN 3C8321 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01184624
Disconnect the harness assembly from inlet air temperature sensor (1) .
Remove inlet air temperature sensor (1) .
Inspect the condition of the O-ring seal on inlet air temperature sensor (1). Replace the O-ring seal, if necessary.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01184624
Install inlet air temperature sensor (1). Tighten inlet air temperature sensor (1) to a torque of 20 5 N m (15 4 lb ft).
Connect the harness assembly to inlet air temperature sensor (1) .