PIN 0857135 - Caterpillar

Illustration 1 g06115708
(1) Fuel tank cap
(2) Hose
(3) ON/OFF switch
(4) Suction valve
(5) Fuel transfer pump
ON/OFF Switch - Push the ON/OFF switch to activate or deactivate the fuel transfer pump. A red indicator on the switch will illuminate when the fuel transfer pump is activated.If one of the following conditions occur, the fuel transfer pump will not activate and/or stop operating:
Battery disconnect switch is in the OFF position
Engine is operating
Engine start switch is moved to the START position.
Engine start switch is in the OFF position
Hydraulic lockout control is not in the LOCKED position
Fuel tank level is full
Fuel is not detected at the suction valve.
30 seconds following a detection of no fuel at the suction valve.Use the following procedure to pump fuel and store the hose.
Park the machine on a level surface. Move the hydraulic lockout control to the LOCKED position. Stop the engine
Turn the engine start switch to the ON position without starting the engine.
Remove fuel tank cap (1) from the fuel tank.
Open the storage box that is on the right side of the machine.
Illustration 2 g03660074
Suction valve (4) is at the end of hose (2).
Turn the end of the suction valve clockwise to open the valve
Uncoil hose (2) and turn the end of suction valve (4) clockwise to open the suction valve.
Properly insert the end of suction valve (4) into a container of fuel.
Push switch (3) to activate the fuel transfer pump and supply the fuel to the tank. A red indicator on the switch will illuminate when the fuel transfer pump is activated.When the fuel tank is full, the fuel transfer pump will automatically stop.When the fuel container is empty, push switch (3) again to stop refueling. If additional fuel is needed, wait 30 seconds and return to step 6.Note: The red indicator on the switch will no longer illuminate when the fuel transfer pump has stopped refueling.Note: The fuel transfer pump will not activate for 30 seconds following a detection of no fuel at the suction valve.
Push switch (3) at any time to deactivate the fuel transfer pump.Note: The red indicator on the switch will no longer illuminate when the fuel transfer pump has stopped refueling.
Drain excess fuel from hose (2) and turn the end of suction valve (4) counter-clockwise to close the suction valve.
When you store hose (2), wind the hose on the bar. Secure the suction valve in place.
To prevent hose damage, do not coil the hose in a tight radius.
Close the cover of the storage box.
install fuel tank cap (1) to the fuel tank.
Turn the engine start switch to the OFF position.