PIN AS 3236551 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-8440 Component Cleaner -
B - Loctite 620 -
Align marks on housings.
Illustration 1 g06292203
Clean the contact surfaces of thrust washer (14) and case assembly (12) with Tooling (A).
Apply Tooling (B) to the contact surfaces of thrust washer (14). Install thrust washer (14) in case assembly (12).
Apply Tooling (B) to the threads of screws (13). Install screws (13).
Illustration 2 g06292202
Install bevel gear (11) in case assembly (12).
Illustration 3 g06292201
Install sleeve bearings (8), pinion gears (9), and thrust washers (10) onto spider (7).
Illustration 4 g06292199
Install spider gear assembly (6).
Illustration 5 g06292198
Install bevel gear (5).
Illustration 6 g06292197
Clean the contact surfaces of thrust washer (3) and case assembly (2) with Tooling (A).
Apply Tooling (B) to the contact surfaces of thrust washer (3). Install thrust washer (3) in case assembly (2).
Apply Tooling (B) to the threads of screws (4). Install screws (4).
Illustration 7 g00334070
A new differential group or a new case assembly will be equipped with four bolts and washers that are used for shipping, assembly, and storage purposes only. Remove and discard these four bolts and washers after the bevel gear has been installed. These four bolts and washers should not use for final assembly.
Align and install case assembly (2). Install the washers and bolts (1) to hold the two halves of the differential case together. Bolts (1) and washers are used to hold the differential case together until final assembly. Remove bolts (1) and washers and discard bolts (1) and washers after installation of the bevel gear.End By:
Install the differential and bevel gear.