PIN 4F2575 - Caterpillar

5. Disconnect air cleaner indicator line (5) from the fitting in the air inlet manifold.6. Disconnect water temperature sensing unit (6). Remove clips (7) that hold the water temperature sensing line in place. 7. Disconnect wire (8) for the lights. Disconnect battery cable (9) from the starting motor. 8. Disconnect oil line (10) from oil line (12). Remove bolt (11) that holds the clips to the bracket. 9. Disconnect wire (13) for the bucket positioner kickout. 10. Disconnect governor linkage (15) from the governor lever. Disconnect fuel supply line (14). Put plugs in the openings. 11. Loosen nut (16) and remove the governor linkage from the bracket.12. Disconnect oil line (17) from oil line (18). 13. Remove the floor plates from the cab or the operator's platform.14. Disconnect transmission control linkage (19) from the lever on the transmission.15. Disconnect wire harness (20). Disconnect wires (22) for the back-up warning alarm.16. Disconnect oil line (23) from the transmission.17. Remove clamps (21) that hold the battery cable to the transmission. 18. Remove bolt (25) and nut that hold clip (24) to bracket (26).19. Disconnect oil line (27) from the steering clutch control valve. 20. Disconnect torque converter oil temperature sensing unit (29) from the transmission.21. Remove transmission oil filler tube (30) from the transmission.22. Remove the bolt that holds the clamp for the torque converter oil cooler lines (28) and the ground strap to the left side of the frame. 23. Remove the head bolt and install tool (A) on the right rear of the cylinder head. Fasten a hoist to the rear lifting bracket and tool (A).24. Fasten tool (B) to the front lifting bracket. 25. Put a hydraulic floor jack under the transmission.26. Remove bolt (31), sleeve and mount assembly (32) from each side of the rear transmission support group.27. Lift the transmission with the hydraulic floor jack and remove rear support assembly (33) from each side of the transmission. 28. Remove bolt (36) that holds clamp (37) to the frame.29. Remove a bolt (34), sleeve and mount assembly (35) from each side of the engine front support group. 30. Fasten a hoist to the crosstube of the loader frame as shown. Remove the support bracket. See the topic, Install And Remove Support Bracket (931C). Lower the bucket to the ground. Make a final check to be sure all removals and disconnections have been made from the engine and transmission.31. Remove engine (38) and the transmission from the machine. The weight of the engine and transmission is 720 kg (1600 lb.). The following steps are for installation of the engine and transmission.32. Install tool (A) on the right rear of the cylinder head. Fasten a hoist to the rear lifting bracket and tool (A). Install tool (B) on the front lifting bracket and fasten it to the hoist. Put the transmission and engine (38) in position in the machine.33. Install bolt (36) that holds clamp (37) for the torque converter oil cooler lines in place.34. Install mount assembly