PLATE 0876335 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-8306 Spanner Wrench 1
B 1U-8840 Duo-Cone Seal Installer As 1
169-0503 Installation Kit 1
C 6V-5765 Sealant 1
Illustration 1 g01075537
Use two people and place minor bogie (14) in a suitable press. The weight of the minor bogie is approximately 24 kg (53 lb).
Lower the temperature of shaft (9). Install shaft (9) in minor bogie (14) until dimension (A) is 14.8 2 mm (0.6 0.08 inch).
Repeat Step 2 in order to install the other shaft in minor bogie (14).
Illustration 2 g01075343
Use two people and install the minor bogie in a suitable vise. The weight of the minor bogie is approximately 28 kg (62 lb).
Raise the temperature of retainer (13). Install retainer (13) on shaft (9).
Use Tooling (B) and install Duo-Cone seal (12) on retainer (13).
Repeat Steps 5 and 6 in order to install the remaining retainers and Duo-Cone seals on the shafts.
Illustration 3 g01075342
Install bearing cups on both sides of roller assembly (1). Install bearing cone (11) in roller assembly (1).
Use Tooling (B) and install Duo-Cone seal (10) on roller assembly (1).
Illustration 4 g01075341
Install roller assembly (1) on shaft (9). Install bearing cone (8).
Illustration 5 g01075340
Install bearing washer (7), lockwasher (5), and nut (6). Use Tooling (A) and tighten nut (6) to a torque of 34 7 N m (25 5 lb ft). Bend the aligned tang from lockwasher (5) into the slot on nut (6).
Illustration 6 g01075339
Apply Tooling (C) to cover (4). Install cover (4) and bolts (3).
Fill roller assembly (1) with oil. Refer to Operation and Maintenance Manual, "Track Roller Bearings - Lubricate".
Install plug (2).
Repeat Steps 8 through 14 in order to assemble the remaining roller assemblies. End By:
Install the rear bogie. Refer to Disassembly and Assembly, "Bogie (Rear) - Install".
Install the front bogie. Refer to Disassembly and Assembly, "Bogie (Front) - Install".