PLATE-BACKING 2609555 - Caterpillar

Improper lubrication can cause damage to machine components.To avoid damage, make sure that the proper amount of grease is applied to the swing drive.When the amount of grease in the compartment becomes too large, the agitation loss becomes large, thereby accelerating grease deterioration.Grease deterioration can cause damage to the pinion gear of the swing drive and swing internal gear. Not enough grease will result in poor gear lubrication.
Illustration 1 g01069240Remove the inspection cover that is located near the boom base.
Illustration 2 g01174015
(1) Access Cover
Remove bolts and washers. Remove the cover (1) and the gasket.
Inspect the gasket. Replace the gasket if damage is evident.
Check the level of the grease. The grease should be evenly distributed on the floor of the pan. Refer to Operation and Maintenance Manual, "Refill Capacities" for the size of the pan.Add grease, as needed. Remove grease, as needed. Too much grease will result in the deterioration of the grease because of excessive movement of the grease. Too little grease will result in poor lubrication of the swing gear.
Check for contamination and for discolored grease.
If the grease is contaminated or discolored with water, change the grease.
Raise the boom and turn the upper structure by 1/4 turn. Lower the cutting attachment to the ground.
Repeat Step 6 at every 1/4 turn in four places. Add grease, as needed.
Install the gasket, the cover, the washers, and the bolts.