PUMP & MOUNTING GP 2003365 - Caterpillar

Install Tooling (C) on the tilt link, as shown. Remove the sleeve bearing from each end of the tilt link.
Illustration 13 g00517545
Remove lip seals (14) from the tilt lever.
Illustration 14 g00517552
Use Tooling (D) to remove the sleeve bearing from the tilt lever. Installation Procedure
Illustration 15 g00517552
Use Tooling (D) to install the sleeve bearing in the tilt lever. Install the sleeve bearing to a depth of 9.50 0.25 mm (0.374 0.010 inch) below the outside surface of the tilt lever.
Illustration 16 g00517545
Put Tooling (G) in the bores of the tilt lever. Use Tooling (B) to install a lip seal (14) on each side of the tilt lever. Install the lip of the seal toward the outside of the tilt lever. Put Tooling (H) on the lip of the seals.
Illustration 17 g00517536
Use Tooling (C) to install a sleeve bearing on each end of the tilt link. Install the sleeve bearing to a depth of 9.50 0.25 mm (0.374 0.010 inch) below the outside surface of the tilt link.
Illustration 18 g00517532
Put Tooling (G) in the bores of the tilt link. Use Tooling (F) to install a lip seal (13) on each side of tilt link (12). Install the lip of the seal toward the outside of the tilt link. Put Tooling (H) on the lip of the seals.
Put Tooling (H) in all pin bores on the pin assemblies.
Illustration 19 g00517512
Put the tilt link in position in the tilt lever. Install pin assembly (11).
Install bolt (10), the washer, and the spacer to pin assembly (11). Tighten bolt (10) to a torque of 460 60 N m (339 44 lb ft).
Illustration 20 g00517505
Fasten a suitable lifting device to tilt lever (9). Put the tilt lever and the tilt link in position in the lift arms. The combined weight of tilt lever (9) and the tilt link is approximately 352 kg (775 lb).
Illustration 21 g00517444
Fasten a suitable lifting device to pin assembly (8). Install pin assembly (8). Install bolt (7), the washer, and the spacer to pin assembly (8). Tighten bolt (7) to a torque of 460 60 N m (339 44 lb ft). The weight of the pin assembly is approximately 27 kg (60 lb).
Illustration 22 g00518245
Use a suitable lifting device to put link (6) in position on the bucket. Install pin assembly (5). Install bolt (4), the washer, and the spacer to pin assembly (5). Tighten bolt (4) to a torque of 460 60 N m (339 44 lb ft).
Illustration 23 g00517366
Fasten a suitable lifting device to tilt cylinder (3), as shown. Put the tilt cylinder in position in the tilt lever. Start the machine. Extend the rod assembly of the tilt cylinder until the pin bore is in alignment with the pin bore of the tilt lever.
Illustration 24 g00517098
Install pin assembly (2). If necessary, use Tooling (E) to install the pin assembly.
Install bolt (1), the washer, and the spacer to pin assembly (2). Tighten bolt (1) to a torque of 460 60 N m (339 44 lb ft). End By:
Install tilt