RACE 2749256 - Caterpillar

Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, which ever occurs first.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.Note: For maintenance information for the truck chassis and the truck engine, refer to the "OEM Service Manual" .Note: For maintenance information for the triplex pump, refer to the "OEM Service Manual" .Note: For maintenance information for the transmission, refer to the "OEM Service Manual" .When Required
Batteries - Replace
Battery - Recycle
Battery or Battery Cable - Disconnect
Fan Drive Bearing - Lubricate
Fuel System - Prime
Daily
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Driven Equipment - Inspect/Replace/Lubricate
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Every 3000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
First 18 950 L (5000 US gal) of Fuel or 125 Service Hours
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Inspect/Adjust
Every 18 950 L (5000 US gal) of Fuel or 125 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Speed/Timing Sensor - Clean/Inspect
Fuel System Primary Filter/Water Separator Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Power End Oil and Filter - Change
Every 37 900 L (10 000 US gal) of Fuel or 250 Service Hours
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Drive Shaft Universal Joints - Lubricate
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Engine - Clean
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 151 600 L (40 000 US gal) of Fuel or 1000 Service Hours
Cooling System Coolant Analysis (Level II) - Obtain
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Engine Mounts - Check
Engine Protective Devices - Check
Engine Valve Lash - Inspect/Adjust
Turbocharger - Inspect
Every 341 100 L (90 000 US gal) of Fuel or 2250 Service Hours
Connecting Rod Bearings - Inspect/Replace
Every 454 800 L (120 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Water Temperature Regulator - Replace
Every 511 650 L (135 000 US gal) of Fuel or 5400 Service Hours
Alternator - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Overhaul Considerations
Water Pump - Inspect