RIVET 0001384 - Caterpillar

Remove dowel (64) that holds gear assembly (60) to shaft (56). Remove gear assembly (60) from shaft (56) .
Illustration 102 g00697601
Use ten 1/8 inch roll pins (65) to compress the ring that holds carrier (57) in position in gear (58). Separate the carrier and gear (58) .
Remove the ring from carrier (57) .
Illustration 103 g00697602
Illustration 104 g00697607
Use a hammer and a punch to push pins (67) in shafts (66) .
Remove shafts (66), gears (68), and discs (69) and (70) from carrier (57) .
Remove pin (67) from the shaft.
Remove bearing (70) from gear (68) .
Illustration 105 g00697608
Remove gear (72) .
Illustration 106 g00697611
Remove housing (73) from the cover assembly.
Illustration 107 g00697613
Use Tooling (E) to remove snap ring (75) from the housing.
Remove shaft (76) and bearing (74) from the housing as an assembly.
Illustration 108 g00697614
Remove ring (77) from shaft (76) .
Use Tooling (B) to remove snap ring (78) from the shaft. Remove bearing (74) .
Illustration 109 g00697617
Use Tooling (B) to remove snap ring (79) .
Remove carrier assembly (80) from the housing.
Illustration 110 g00697621
Remove ring (81) from carrier assembly (80) .
Illustration 111 g00697624
Remove bearing (82) from carrier assembly (80), if necessary.
Illustration 112 g00697628
Illustration 113 g00697630
Use a hammer and a punch to push the pins in shafts (83). Remove the shafts from carrier assembly (84). Remove the pins from the shaft.
Remove discs (87) and (88) from the carrier assembly.
Remove bearings (86) and (89) from gears (85) .
Illustration 114 g00697632
Remove piston (91) from housing (73). Remove the rings from the piston.
Use Tooling (E) to remove snap ring (90) from housing (73) .
Remove bearing (92) from the housing.