SEAL-O-RING 0619457 - Caterpillar

Illustration 1 g01417896Note: The top face of the gasket and the top face of the cylinder block, cylinder liners and the bottom face of the gasket and the bottom face of the cylinder head must be free of oil, fuel, water and other contaminants before assembly.Note: Use clean engine oil to lubricate the threads of the cylinder head bolts before assembly.Use the following procedure to tighten the cylinder head bolts:
Torque the bolt (1) through bolt (26) in a numerical sequence to 130 15 N m (95 11 lb ft).
Again torque the bolt (1) through bolt (26) in a numerical sequence to 130 15 N m (95 11 lb ft).
Place a mark on bolt (1) through bolt (26). Rotate the bolt (1) through bolt (26) in the clockwise direction in a numerical sequence to 90 degrees (1/4 turn).
Loosen the bolt (1) through bolt (26) in a numerical sequence to 0 N m (0 lb ft).
Repeat Step 1 through Step 3.
Torque the bolt (27) through bolt (31) in a numerical sequence to 28 7 N m (21 5 lb ft).
Illustration 2 g01417900Note: Apply 6V-6640 Sealant to the bore of the cup plugs before assembly. (C) The cup plugs (Y) are measured from the head face to the top edge of the plug. Depth of installation ... 2.0 0.5 mm (0.08 0.02 inch) (D) The cup plugs (X) are measured from the head face to the top edge of the plug. Depth of installation ... 1.5 0.5 mm (0.06 0.02 inch)
Illustration 3 g01417914 (32) Torque for the plugs ... 350 30 N m (260 22 lb ft) (E) Height of new cylinder head ... 130.00 0.15 mm (5.118 0.006 inch)Note: The flatness of the cylinder head should be within 0.15 mm (0.006 inch). The flatness should also be a maximum of 0.05 mm (0.002 inch) for any 150.00 mm (5.906 inch) span.