0951510 SEAL-O-RING Caterpillar parts
311B, 312B L, 315B L, 317B LN, 318B, 320B, 320B L, 322B L, 322B LN, 325B, 325B L, 330B, 330B L, 345B, 345B II, 345B II MH, 345B L, 365B, 365B II, 365B L, 385B, 5090B, 539, E110, E120, E140, E180, E240...
Rating:
Alternative (cross code) number:
CA0951510
095-1510
0951510
CA0951510
095-1510
0951510
Weight: 0.01 pounds 0 kg.
Information:
CROSS SECTION DIAMETER
1.9
mm
ID
4.8
mm
MATERIAL
Nitrile (NBR) Rubber - 75 Duro
OD
0
mm
EXCAVATOR, WHEELED EXCAVATOR,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$4.39
08 Dec 2018
CATERPILLAR AFTERMARKET: CATERPILLAR AFT
CATERPILLAR SEAL O RING 0951510 NEW
$5.92
16 Nov 2021
0.1102[0.05] Pounds
US: IronDT
CTP Caterpillar Nbr (75) O-Ring (0951510) Aftermarket
CTP
CTP
Number on catalog scheme:
19
For full view, you need register
Compatible equipment models: 0951510:
Information:
Test Procedure
System Operation
A thermocouple is a temperature sensor. The thermocouple consists of two different metals. The metals are joined together at one end. A small voltage is produced when the junction is heated. The change in voltage is interpreted by an electronic device in order to determine a change in temperature. The system uses K type thermocouples. The K type thermocouples have ranges from −200 °C (−328 °F)to 1260 °C (2300 °F). This temperature range corresponds to a voltage range of negative 5.9 mV to 51.0 mV.The signal is used in order to trigger alarms and the signal is used in order to display the parameter.
Illustration 1 g00563634
Diagram of the thermocoupleFunctional Test
Note: The 163-0096 Diagnostic and Calibration Tool can be used in order to troubleshoot this component. Refer to the "Owner's Manual" for more information.
Check the electrical connectors and check the wiring.
Bodily contact with electrical potential can cause bodily injury or death.To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules.
Disconnect the power supply.
Check the electrical connectors and check the wiring for damage or bad connections.
Verify that all modules are properly seated.
Verify the status of the LED on the SLC 5/04 - 5/05.The results of the preceding procedure are in the following list:
All of the components are fully installed. All of the components are free of corrosion. All of the components are free of damage. All of the modules are properly seated. Stop.
The components are not fully installed. The components are not free of corrosion. The components are damaged. All of the modules are not properly seated. Repair the component. Verify that the repair resolves the problem. STOP.
System Operation
A thermocouple is a temperature sensor. The thermocouple consists of two different metals. The metals are joined together at one end. A small voltage is produced when the junction is heated. The change in voltage is interpreted by an electronic device in order to determine a change in temperature. The system uses K type thermocouples. The K type thermocouples have ranges from −200 °C (−328 °F)to 1260 °C (2300 °F). This temperature range corresponds to a voltage range of negative 5.9 mV to 51.0 mV.The signal is used in order to trigger alarms and the signal is used in order to display the parameter.
Illustration 1 g00563634
Diagram of the thermocoupleFunctional Test
Note: The 163-0096 Diagnostic and Calibration Tool can be used in order to troubleshoot this component. Refer to the "Owner's Manual" for more information.
Check the electrical connectors and check the wiring.
Bodily contact with electrical potential can cause bodily injury or death.To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules.
Disconnect the power supply.
Check the electrical connectors and check the wiring for damage or bad connections.
Verify that all modules are properly seated.
Verify the status of the LED on the SLC 5/04 - 5/05.The results of the preceding procedure are in the following list:
All of the components are fully installed. All of the components are free of corrosion. All of the components are free of damage. All of the modules are properly seated. Stop.
The components are not fully installed. The components are not free of corrosion. The components are damaged. All of the modules are not properly seated. Repair the component. Verify that the repair resolves the problem. STOP.
Caterpillar parts catalog:
Parts seal Caterpillar catalog:
345B II, 345C, 345D, 345D L, 349D, 349D L
345B II, 345C, 345D, 345D L, 349D, 349D L
365C, 374D L, 374F L, 385B, 385C, 385C L, 390D, 390D L, 390F L
330B, 330B L, 330C L, 330D, 330D L, 336D
330B, 330B L, 330C L, 330D, 330D L, 336D
345B II, 345C, E120, E140, E180, E240, E240C, E300, E300B, E450, EL240B
E180, E200B, E240, EL240B
325B L
330B, 330B L
330, 330B
325B
115, 2384C, 2484C, 311B, 311C, 311D LRR, 311F LRR, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320B, 320B L, 320C, 320C FM, 320C L, 320D,...
2384C, 2484C, 311B, 311C, 311D LRR, 311F LRR, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D...
2384C, 2484C, 312B, 312B L, 315B L, 317B LN, 318B, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D2, 320D2 GC, 320D2 L, 321B, 322B L, 322B LN, 322C, 322C FM, 323D L, 323D LN...
2384C, 2484C, 311B, 311C, 311D LRR, 311F LRR, 312B, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320B, 320B L, 320C, 320C FM, 320C L, 320D...
312B, 312B L, 312C, 312C L, 313B, 315B, 315B L, 315C, 317B LN, 318B
1262149
SEAL-BUFFER
307B, 311B, 312B, 312B L, 313B, 330B L
307B, 311B, 312B, 312B L, 313B, 330B L
2384C, 2484C, 308E, 311, 311B, 312B, 312B L, 313B, 315B, 315B FM L, 315B L, 317B LN, 318B, 318E L, 319D L, 319D LN, 320C, 320D, 320D FM, 320D GC, 320D L, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 3...
311B, 311C, 311D LRR, 311F LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313B, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C...
2318593
SEAL-O-RING
312B L, 312C, 315B L
312B L, 312C, 315B L
4I8889
SEAL-RECTANGULAR
307, 307B, 307C, 311, 311B, 311C, 312, 312B, 312B L, 312C L, 313B, 314C, 315, 315B, 315B FM L, 315C, 318B, 320, 320 L, 320B, 320B L, 320B U, 320C, 320N, 322B, 325, 325B, 325C, 328D LCR, 330B, 330B L, ...
307, 307B, 307C, 311, 311B, 311C, 312, 312B, 312B L, 312C L, 313B, 314C, 315, 315B, 315B FM L, 315C, 318B, 320, 320 L, 320B, 320B L, 320B U, 320C, 320N, 322B, 325, 325B, 325C, 328D LCR, 330B, 330B L, ...
2384C, 2484C, 311C, 311D LRR, 311F LRR, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM R...
2384C, 2484C, 302.5, 303, 311C, 311D LRR, 311F LRR, 312B L, 312C, 312C L, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315B L, 315C, 317B LN, 318B, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D,...