SEAL 1269092 - Caterpillar

2. Install spacer (1), spring (2) and spacer (3) in barrel (5). 3. Put the barrel in position in a press. Put the plastic protective plate from tooling (A) on the barrel face. Put tool (A) between the press head and spacer (3). Push down on spring (2) and install snap ring (4). 4. Lower the temperature of bearing cups (8). Install the cups in swashplate (7).5. Install the two inserts (6) in the swashplate. 6. Heat bearing cones (9) for both covers in oil to a maximum temperature of 275°F (135°C). Install the cones on the covers. 7. Install O-ring seals on bolts (10). Install the locknuts that hold the bolts.8. Lower the temperature of bearing cup (11) and install the cup in the pump body.9. Install tool (D) on the pump body and bolts (10). 10. Turn the bolts (10) clockwise to decrease the dimension and counterclockwise to increase the dimension. Measure the distance between the top of the pump body and the ends of the bolts (10).11. Dimension (G) must be 5.910 .005 in. (150.11 0.13 mm). Dimension (H) must be 6.850 .005 in. (173.99 0.13 mm).12. Hold the bolts as the locknuts are tightened. Tighten the locknuts