SEAT 1659436 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 243 -
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Release the system pressure. Refer to Operation and Maintenance Manual, "System Pressure - Release" for the correct procedure.
Illustration 1 g06311339
Disconnect four hose assemblies (2) from manifold valve (1).
Illustration 2 g06311349
Disconnect six hose assemblies (3) from manifold valve (1).
Illustration 3 g06321650
Remove three mounting bolts (4) and the washers from manifold valve (1). Remove manifold valve (1).Installation Procedure
Install manifold valve (1) in the reverse order of removal.
Apply Tooling (A) to the threads of mounting bolts (4).