SHAFT-BEVEL-YM 2234806 - Caterpillar

Reference: Refer to Operation and Maintenance Manual, SEBU7351, "Product Link" for instructions about registering your Product Link.Installation Procedure
Before you begin the procedure, record the serial number and the model number. These numbers are located on the communication electronic control module (1). These numbers will be used to register your Product Link.Serial Number ____________________Model Number ____________________
Disconnect the battery.
Remove the rear part of the headliner and the front part of the headliner. Remove the foam.
Illustration 9 g00991196
Attach two plates (2) to communication electronic control module (1) with four bolts (3) .
Illustration 10 g00991244
Illustration 11 g00991030
Install the module assembly on the underside of the canopy at the location that is shown in Illustration 10. Use existing tapped holes (A) in the canopy. Use four bolts (4), four washers (5), four spacers (6), and eight rubber mounts (7). Refer to Illustration 11.
Illustration 12 g00991276
Harness Routing (view through top of canopy)
Illustration 13 g00991277
Harness routing (view from underside of canopy)
Install harness (8). Refer to Illustrations 12 and 13 for the correct routing. Use cable straps (9) to secure the harness.
Attach the ground strap to either of the two mounting locations on the front side of the ECM.
Reinstall the headliner.Note: The headliner may be equipped with a foam insert. The foam insert fills the hole in the headliner when Product Link is not installed. This insert may be discarded after Product Link is installed.
Illustration 14 g00991286
Mount bracket (11) with two existing bolts (B) and two existing washers (C) to the canopy. Secure harness (8) with clip (10) .
Install antenna (12) on bracket (11). Tighten the antenna to 5 0.5 N m (45 5 lb in).
Connect the antenna to the harness.
Illustration 15 g01044898
Illustration 16 g00991297
Install label (13) to the inside of the left ROPS post. Refer to Illustration 16. The warning is shown in Illustration 15.
Register your Product Link. Refer to Operation and Maintenance Manual, SEBU7351, "Product Link".