STARTING MOTOR GP-ELECTRIC 1970986 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-8359 Eyebolt 1
B 2P-8312 Retaining Ring Pliers 1 Start By:
Connect the steering frame lock.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the oil from the final drive. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil - Change" for the correct draining and filling procedure.
Illustration 1 g01146451
Remove bolts (1) and cover (2).
Illustration 2 g01146456
Remove O-ring seal (3).
Illustration 3 g01146462
Install Tooling (A) to axle shaft (4). Use Tooling (A) in order to pull axle shaft (4) outward for approximately 762 mm (30.0 inch).
Illustration 4 g01146489
Attach a suitable lifting device to axle shaft (4). Use Tooling (A) and the suitable lifting device to remove axle shaft (4). The weight of axle shaft (4) is approximately 68 kg (150 lb).
Illustration 5 g01146499
Use Tooling (B) in order to remove retaining ring (5) from axle shaft (4).
Illustration 6 g01146505
Remove sun gear (6) and spacer (7) from axle shaft (4).
Repeat Step 1 through Step 7 for the remaining axle shafts. Installation Procedure
Install axle shaft (4) in the reverse order of removal.