2641765 STICK & BEARING AS Caterpillar parts
324D, 324D L
Rating:
Alternative (cross code) number:
CA2641765
264-1765
2641765
CA2641765
264-1765
2641765
Weight: 2068 pounds 938 kg.
EXCAVATOR,
Number on catalog scheme:
8
For full view, you need register
Information:
Do not check for leaks with your hands. Pin hole (very small) leaks can result in a high velocity oil stream that will be invisible close to the hose. This oil can penetrate the skin and cause personal injury. Use cardboard or paper to locate pin hole leaks.
Inspect all oil lines, hoses, and connections for damage or for leaks. Look for oil on the ground under the machine.Note: If oil can leak out of a fitting or a connection, air can leak into the system. Air in the system can be as bad as a low amount of oil.
Check the electrical system.Inspect the circuit breaker for the Chassis Electronic Control Module, the harnesses, and the electrical connectors. Refer to the proper Electrical Schematic.With the engine start switch and the battery disconnect switch in the OFF position, check the circuit breaker for the Chassis Electronic Control Module. If the circuit breaker is open, reset the circuit breaker.Inspect the electrical harnesses for damaged wires or for broken wires. Disconnect each connector and look for pins and sockets that have been bent, broken, or removed. Look for any foreign material inside the connectors. The connectors must be tightened with normal force. The connectors must be disconnected with the same amount of force.For additional instructions, refer to Service Manual, "773G and 775G Chassis ECM".
Check the batteries.Check the batteries. Turn the battery disconnect switch ON.
Check the filters and the screens.Inspect the power train oil filter, the transmission magnetic screen, and the suction screens.Note: The power train oil filter has a bypass valve. A bypass valve allows oil to bypass the filter whenever the difference in pressure between the inlet and outlet oil is too high. Any oil that does not go through the filter elements goes directly in the hydraulic circuit. Dirty oil causes restrictions in the valve orifices and sticking valves. Restrictions can then cause clutch failures.If contamination is found in the power train oil filter or screens, all components of the transmission, torque converter, and power train hydraulic system must be cleaned. Do not use any damaged parts. Any damaged parts must be removed and new parts must be installed.
Caterpillar parts catalog:
Parts stick Caterpillar catalog:
3529545
STICK & BEARING AS
324D, 324D L, 326D L
324D, 324D L, 326D L
2602368
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2542909
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2542938
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2824545
STICK & BEARING AS
324D, 324D L
324D, 324D L
2909243
STICK & BEARING AS
324D, 324D L
324D, 324D L
2909246
STICK & BEARING AS
324D, 324D FM, 324D L, 324D LN
324D, 324D FM, 324D L, 324D LN
2909258
STICK & BEARING AS
324D, 324D L, 324D LN, 326D L
324D, 324D L, 324D LN, 326D L
3986996
STICK & BEARING AS
324D, 324D L, 326D L
324D, 324D L, 326D L
2909255
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2941493
STICK & BEARING AS
324D L, 324D LN
324D L, 324D LN
2444236
STICK & BEARING AS
324D, 324D FM, 324D L, 324D LN
324D, 324D FM, 324D L, 324D LN
2909226
STICK & BEARING AS
323D L, 323D2 L
323D L, 323D2 L
2909220
STICK & BEARING AS
323D L, 323D LN
323D L, 323D LN
2909217
STICK & BEARING AS
323D L, 323D LN
323D L, 323D LN
2909211
STICK & BEARING AS
323D L, 323D LN
323D L, 323D LN
2417328
STICK & BEARING AS
323D L, 323D LN, 323D SA
323D L, 323D LN, 323D SA
2824545
STICK & BEARING AS
324D, 324D L
324D, 324D L
2542938
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2542909
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
2602368
STICK & BEARING AS
324D, 324D L, 324D LN
324D, 324D L, 324D LN
3529545
STICK & BEARING AS
324D, 324D L, 326D L
324D, 324D L, 326D L