SWASHPLATE 2042777 - Caterpillar

Table 2
Required Parts
Item Qty Part Number Description
1 1 384-7724 Plate As
2 1 9D-6584 Lip Type Seal
3 1 167-2307 U-Cup Seal
4 1 4T-8054 Seal As
5 1 2H-3931 O-Ring Seal
6 1 3J-1907 O-Ring Seal
7 1 9D-3311 Bushing
8 1 3E-3636 Ball Switch Prepare The Machine
Note: Permit only one person on the machine. Either keep others away from the machine, or keep other personnel in the sight of the operator.
Move the machine to a smooth horizontal location. Move away from any machines that are working and any personnel.
Move the transmission control to the PARK position.
Activate the parking brake.
Place blocks in front of the wheels and behind the wheels.
Stop the engine and allow the engine to cool.
Turn battery disconnect switch to the OFF position.
Remove the centershift lock. Refer to Disassembly and Assembly , "Centershift Lock – Remove".Note: Remove the centershift lock. Do not remove the centershift lock bar.
Remove the solenoid valve from the centershift lock. Refer to Disassembly and Assembly , "Solenoid Valve (Centershift Lock) – Remove and Install".
Disassemble the centershift lock to machine the cylinder. Refer to Disassembly and Assembly , "Centershift Lock – Disassemble".
Illustration 2 g06160073
View of cylinder
(A) Cylinder
(B) 81 0.2 mm (3.2 0.01 inch)
(C) 5.5 0.5 mm (0.22 0.02 inch)
Machine the face of cylinder (A) to dimensions (B), (C), and radius of .8 0.2 mm (0.03 0.01 inch). Refer to Illustration 3. Ensure that the machining is centered on the cylinder housing in relation to the existing bore for the pin.
Ensure cylinder (A) is properly cleaned after the machining is completed.
Illustration 3 g06160080
View of lock
(2) 9D-6584 Lip Type Seal
(3) 167-2307 U-Cup Seal
(4) 4T-8054 Seal As
(5) 2H-3931 O-Ring Seal
Assemble the centershift lock. Ensure to use new O-ring seal (5), seal as (4), lip type seal (2), and U-cup seal (3). Refer to Disassembly and Assembly , "Centershift Lock – Assemble".
Install new ball switch (8). Be sure to use new O-ring seal (6) when installing the new ball switch.
Install the solenoid valve. Refer to Disassembly and Assembly , "Solenoid Valve (Centershift Lock) – Remove and Install".
Illustration 4 g06160079
View of lock
(A) Lock
(2) 9D-6584 Lip Type Seal
(7) 3J-1907 O-Ring Seal
(8) 9D-3311 Bushing
(9) 3E-3636 Ball Switch
Install once spacer (2) to the face of the centershift lock.
Install new bushing (7) onto the centershift lock.
Install the centershift lock to the machine. Refer to Disassembly and Assembly , "Centershift Lock – Install".
Ensure that the hydraulic oil level is correct. Refer to Operation and Maintenance Manual , "Hydraulic System Oil Level – Check".