VALVE AS 1972474 - Caterpillar

Illustration 1 g01520680
Use the following procedure to install the turbocharger impeller (1) . This procedure should be done at room temperature.
Install the impeller on the shaft.
Tighten the nut to 31 2 N m (275 18 lb in).Note: Do not bend the shaft, or add stress to the shaft when the nut is loosened or tightened.
Remove the nut.
Apply 169-5464 Quick Cure Primer to the threads of the shaft and the nut.
Apply 4C-4030 Thread Lock Compound to the threads of the shaft and the nut.
Tighten the nut to 5 N m (45 lb in).
Again, tighten the nut to an additional 120 degrees. (2) Torque for the bolts that hold the back plate ... 10.2 to 13.6 N m (90 to 120 lb in)Use the following procedure to tighten the clamp bolts (3) :
Lightly hit around the entire area of the clamp with a soft faced hammer.
Tighten the clamp bolts to 13.55 1.15 N m (120 10 lb in). (A) Diameter of the journal surface on the shaft for the bearing ... 15.875 to 15.885 mm (0.6250 to 0.6254 inch) (B) Bore in the bearing ... 15.910 to 15.918 mm (0.6264 to 0.6267 inch) (C) Outside diameter of the bearing ... 24.846 to 24.859 mm (0.9782 to 0.9787 inch) (D) Bore in the housing ... 24.961 to 24.973 mm (0.9827 to 0.9832 inch) (4) Clearance between the ends of the oil seal ring ... 0.10 to 0.28 mm (0.004 to 0.011 inch) (E) End play for the shaft ... 0.08 to 0.12 mm (0.003 to 0.005 inch)Note: Apply 4C-5599 Anti-Seize Compound on the threads of the bolts that hold the turbocharger to the exhaust manifold. (5) Tighten the bolts and the nuts that hold the turbocharger to the exhaust manifold to the following torque. ... 54 5 N m (40 4 lb ft)