2502587 VALVE GP-CONTROL Caterpillar parts
320C
Rating:
Alternative (cross code) number:
CA2502587
250-2587
2502587
CA2502587
250-2587
2502587
Weight: 220 pounds 99 kg.
EXCAVATOR,
Compatible equipment models: 2502587:
Number on catalog scheme:
1
For full view, you need register
Information:
Electric Starting Motor
Maintain the proper level of electrolyte in the batteries. Keep the batteries fully charged.To maximize the battery power, heat the battery compartment or store the batteries in a warm location. Typically, batteries only have 50 percent of the capability at −10 °C (14 °F) versus 27 °C (80 °F).Extra battery capacity may be necessary for cold temperatures.Heaters
Note: Oil pan immersion heaters are not recommended for heating the lube oil. To ensure the compatibility of the components, only use equipment that is recommended by Caterpillar.Startability will be improved at temperatures below 12 °C (55 °F) with a starting aid. A jacket water heater may be needed and/or the crankcase oil may require warming.Note: The fluid that is heated must be circulated continuously. This procedure will help to prevent localized overheating of the fluid.A jacket water heater is available as an option for starting in temperatures as low as 0 °C (32 °F). The jacket water heater can maintain the water temperature at approximately 32 °C (90 °F). The heated water will help to keep the oil in the engine block warm enough to flow when the engine is started.When No. 2 diesel fuel is used, a fuel heater will maintain the temperature of the fuel above the cloud point. Fuel line insulation will help to maintain the fuel temperature.Consult your Cat dealer for more information on the starting aids that are available for cold weather starting.Air Starting Motor
Note: Air starters will require air pressure regulation if the air supply exceeds the air pressure requirements that are listed in table 1
Table 1
Air Starter Maximum Air Pressure Requirements Air Consumption at Maximum Operating Pressure
Air Starter Configuration Maximum Operating Air Pressure
Right-Hand Air Starter with Oil Mist Detection 621 kPa (90 psi) 1606 SCFM (45.7 m3/min
Right-Hand Air Starter without Oil Mist Detection 690 kPa (100 psi) 925 SCFM (26.2m3/min
Left-Hand Air Starter 690 kPa (100 psi) 925 SCFM (26.2m3/min To start the engine at colder temperatures, the following conditions may be necessary:
Maximum air pressure for the starting motor
An extra volume of air
Maintain the proper level of electrolyte in the batteries. Keep the batteries fully charged.To maximize the battery power, heat the battery compartment or store the batteries in a warm location. Typically, batteries only have 50 percent of the capability at −10 °C (14 °F) versus 27 °C (80 °F).Extra battery capacity may be necessary for cold temperatures.Heaters
Note: Oil pan immersion heaters are not recommended for heating the lube oil. To ensure the compatibility of the components, only use equipment that is recommended by Caterpillar.Startability will be improved at temperatures below 12 °C (55 °F) with a starting aid. A jacket water heater may be needed and/or the crankcase oil may require warming.Note: The fluid that is heated must be circulated continuously. This procedure will help to prevent localized overheating of the fluid.A jacket water heater is available as an option for starting in temperatures as low as 0 °C (32 °F). The jacket water heater can maintain the water temperature at approximately 32 °C (90 °F). The heated water will help to keep the oil in the engine block warm enough to flow when the engine is started.When No. 2 diesel fuel is used, a fuel heater will maintain the temperature of the fuel above the cloud point. Fuel line insulation will help to maintain the fuel temperature.Consult your Cat dealer for more information on the starting aids that are available for cold weather starting.Air Starting Motor
Note: Air starters will require air pressure regulation if the air supply exceeds the air pressure requirements that are listed in table 1
Table 1
Air Starter Maximum Air Pressure Requirements Air Consumption at Maximum Operating Pressure
Air Starter Configuration Maximum Operating Air Pressure
Right-Hand Air Starter with Oil Mist Detection 621 kPa (90 psi) 1606 SCFM (45.7 m3/min
Right-Hand Air Starter without Oil Mist Detection 690 kPa (100 psi) 925 SCFM (26.2m3/min
Left-Hand Air Starter 690 kPa (100 psi) 925 SCFM (26.2m3/min To start the engine at colder temperatures, the following conditions may be necessary:
Maximum air pressure for the starting motor
An extra volume of air
Caterpillar SIS machinery equipment:
Caterpillar SIS
320C, 320C L, 320C LN, 320C S Excavators BBL00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
320C S Hydraulic Excavator EGL00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
320C, 320C L, 320C LN Excavators DBG00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
320C Hydraulic Material Handler EGA00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
320C LN Excavator AXK00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
320C S Hydraulic Excavator BMZ00001-UP (MACHINE) POWERED BY 3066 Engine »
250-2587
VALVE GP-CONTROL
Caterpillar parts catalog:
Parts valve Caterpillar catalog:
315C, 318B, 318C, 319D L, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 320C L, 320D, 320D LRR, 321B, 321C, 322B, 322B L, 322B LN, 322C, 322C FM, 325 L, 325B, 325B L, 330B, 330B L, OEMS
318C, 319C, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D L, 321C, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D L, 325B L, 325C, 325C FM, 325D, 325D FM, 325D L, 329D, 329D L, 330B L, 330C, 3...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 311D LRR, 312D, 315D L, 318C, 319C, 320B, 320B FM LL, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D L, 320D LRR, 320D RR, 321C, 321D ...
318C, 319C, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D L, 321C, 322B L, 322B LN, 322C, 322C FM, 324D, 324D FM, 324D L, 325B L, 325C, 325C FM, 325D, 325D FM, 325D L, 329D, 329D L, 330B L, 330C, 3...
312C L, 318C, 319C, 320B, 320B FM LL, 320B L, 320B U, 320C, 320C FM, 321B, 321C, 322B, 322B L, 322B LN, 322C, 322C FM, 325B, 325B L, 325C, 325C FM, 325D, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, ...
312C L, 315C, 318C, 320B, 320C, 320C FM, 320C L, 321C, 322B L, 322B LN, 322C, 322C FM, 325B L, 325C, 325C FM, 330B L, 330C, 330C FM, 330C L, 330C MH, M325B, M325C MH, W330B
305.5, 306, 306E, 307B, 307C, 307D, 308C, 308D, 311, 311B, 311C, 311D LRR, 312B, 312B L, 312C, 312C L, 312D, 312D L, 313B, 314C, 314D CR, 314D LCR, 315, 315B, 315B L, 315C, 315D L, 317B LN, 318B, 318C...
311, 311B, 311C, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM RR, 320D LRR, 320D RR, 320N, 321C, 321D LCR, 323D L, 323D LN
311, 311B, 311C, 311D LRR, 312, 312B, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 3...
311, 311B, 311C, 312, 312B, 312C, 312C L, 314C, 318C, 319C, 320 L, 320B, 320B U, 320C, 320C FM, 320C L, 320D, 320D LRR, 320N, 321C, 323D L, 323D LN
311C, 312C, 312C L, 314C, 318C, 319C, 320C, 320C FM, 320C L, 320D, 320D LRR, 321C, 323D L, 323D LN
2500574
VALVE GP-BANK 6
120H, 12H, 135H, 140H, 143H, 160H, 163H
120H, 12H, 135H, 140H, 143H, 160H, 163H
2585407
VALVE MECHANISM GP
G3512E, G3516C, G3516E, G3520C, G3520E, PMG3516
G3512E, G3516C, G3516E, G3520C, G3520E, PMG3516
2784442
VALVE GP-PUMP CONTROL
953D, D6K, D6K LGP, PL61
953D, D6K, D6K LGP, PL61
2500552
VALVE GP-BANK 6
120H, 12H, 135H, 140H, 143H, 160H, 163H
120H, 12H, 135H, 140H, 143H, 160H, 163H
2851542
VALVE GP-MAIN CONTROL
330D FM, 330D MH
330D FM, 330D MH
1866591
VALVE GP-CONTROL
D4C III, D5C III
D4C III, D5C III
3640640
VALVE GP-MAIN CONTROL
950H, 962H
950H, 962H
2528039
VALVE GP-PRESSURE REDUCING
769D, 771D, 773D, 773E, 775D, 775E, 776D, 777D, 777F, 824G II, 824H, 825G II, 825H, 826G II, 826H, 950G, 950G II, 950H, 962G, 962G II, 966G II, 972G II, 980G, 980G II, 980H, D10R, D11R, D250E, D300E
769D, 771D, 773D, 773E, 775D, 775E, 776D, 777D, 777F, 824G II, 824H, 825G II, 825H, 826G II, 826H, 950G, 950G II, 950H, 962G, 962G II, 966G II, 972G II, 980G, 980G II, 980H, D10R, D11R, D250E, D300E
2502500
VALVE GP-LOAD CONTROL
318C, 320C, 320C FM, 321C, 322C, 322C FM, 325C, 325C FM, 330C, 330C FM, 330C L, M325C MH
318C, 320C, 320C FM, 321C, 322C, 322C FM, 325C, 325C FM, 330C, 330C FM, 330C L, M325C MH