VALVE GP-LOAD CONTROL 2632064 - Caterpillar

Illustration 2 g00728128
This warning label is positioned in the cab.
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND S IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE S COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY.
ROPS
Illustration 3 g00728156
This warning label is positioned on the outside of the cab on the left side.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
"Rollover (ROPS) and Falling Object (FOPS) Protective Structure Certification ""This structure, when properly installed on a machine which is not altered to exceed the certification test mass meets, at the time of installation, criteria established by: SAE J394, SAE J1040 APR88, ISO 3471-1:1986, ISO 3471:1994, SAE J231 JAN 81, ISO 3449:1992 LEVEL II."No Clearance
Illustration 4 g00728534
This warning label is positioned on each side of the machine at the center pivot.
No clearance for person in this area when machine turns. Severe injury or death from crushing could occur.
"Connect steering frame lock between front and rear frames before lifting, transporting, or servicing machine in articulation area.""Disconnect lock and secure before resuming operation."High Pressure Cylinder
Illustration 5 g00728545
This warning label is positioned at the center pivot on the left side of the machine.
HIGH PRESSURE CYLINDERDo not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved or personal injury may occur.To relieve pressure:
Shut off engine and wait five minutes for hydraulic system pressure to dissipate.
Relieve gas pressure in the accumulator cylinder by opening the charging valve one turn only.Charge cylinder with dry nitrogen gas.Precharge pressure _______ PSI _______kPa.Service pressure (Operating-Loaded) ______PSI ______kPa.Minimum bursting pressure _____PSI _____kPa.See your Caterpillar dealer for tools and detailed information required for charging cylinders.
Compressed Spring
Illustration 6 g00728555
This warning label is located on the parking brake actuator.
Do not attempt to remove spring(s), they are not serviceable. Do not cut, saw, torch or modify this chamber, serious injury or death may result.
Improper Jumper Cable Connection
Illustration 7 g00728596
Open the access panel on the left side of the machine. The warning is positioned on the inside of the battery compartment.
Improper jumper cable connections can cause explosion resulting in personal injury. Batteries may be located in separate compartments, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to engine block or frame.