VALVE GP-EXHAUST GAS (NRS) 3905194 - Caterpillar

Removal Procedure
Start By:
Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Remove the water temperature regulator. Refer to Disassembly and Assembly, "Water Temperature Regulator - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00619289
Illustration 2 g00619272
Remove exhaust manifold shield (3). Remove the nuts and spacers from studs (1). Remove exhaust manifold (2) .
Remove liners (4) from the cylinder head.
Illustration 3 g00498283
Remove gaskets (5) from the cylinder head studs.Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-3931     Anti-Seize Compound     1    
B     2P-2333     High Temperature Sealer     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Before assembly, check the condition of the gaskets, the liners, the studs, and the nuts. If the part is worn or damaged, use new parts for replacement.
Illustration 4 g00619272
Apply Tooling (A) to studs (1). If the studs were removed from the cylinder head, install the studs in the cylinder head. Tighten the studs to a torque of 35 5 N m (26 4 lb ft).
Install liners (4) in the cylinder head.
Illustration 5 g00498283
Install gaskets (5) on the studs.
Illustration 6 g00619289
Illustration 7 g00498448
Apply Tooling (B) to the outside diameter of the male ends of exhaust manifold (2). Apply clean engine oil on the female ends of the exhaust manifold.
Position exhaust manifold (2) on the studs. Install the spacers and nuts on studs (1) .
Tighten the nuts for the exhaust manifold in a numeric sequence to a torque of 38 5 N m (28 4 lb ft).
Install exhaust manifold shield (3). Tighten the nuts for the shield to a torque of 25 7 N m (18 5 lb ft).End By:
Install the water temperature regulator. Refer to Disassembly and Assembly, "Water Temperature Regulator - Remove and Install".
Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".